Search results

  1. A

    Have a live mouse inside a interior wall. No insulation.

    I use "TomCat" appears to be same stuff from the label. They also have traps that contain the mouse, and traps that contain mouse and the poison if you go that route.
  2. A

    Have a live mouse inside a interior wall. No insulation.

    Mouse fishing....sounds like fun !
  3. A

    Have a live mouse inside a interior wall. No insulation.

    Poster says mouse is trapped inside his wall and can't get out....otherwise I would agree with you.
  4. A

    Impeller replacement glycerin and grease

    Dow products were expensive, but have came down considerably in my area. About half the cost today as it was 30 years back. Where you live can mean a lit when it comes to cost...
  5. A

    1978 Islander 22 I/O

    One single LifePo4 battery will give you double the time as two group 27 batteries for about the same cost. Not designed for starting a big motor, but any type of deep cycle work they are awesome ! My 140ah only weighs 30#...
  6. A

    Have a live mouse inside a interior wall. No insulation.

    While shooting it may be more fun, trapping would probably be a better option. If you can't get access with a trap, they make poisons that actually keep them from stinking thru the chemicals they eat in the poison. Within days they turn to a clump of dust or powder. "D Con" was one of the...
  7. A

    Does anyone know what this plug is called ??

    Yep...have to agree with ya....I was always taught that a grommet fit inside a hole to protect the sharp edges from chewing up any wires or hoses that passed thru that hole in the grommet. If no hole then it was called a cover. Years back made a tool ( mold) that cast these things from plastic...
  8. A

    Gas Pressure washer "turn off" instructions incorrect??

    Often it depends on where you buy the fuel to begin with. If your buying fuel that has not had the filters changed or the storage tanks are full of crap, your fuel will be crap. Never buy fuel when the underground tanks are being filled as that stirs up the crap in the bottom of the tank. We...
  9. A

    Gas Pressure washer "turn off" instructions incorrect??

    Very true, been using E10 since it came onto the market, add a fuel stabilizer like have always done for the past 60 plus years....never have had a clog or any other issue with it !
  10. A

    Gas Pressure washer "turn off" instructions incorrect??

    YES....use the pink RV antifreeze as it is designed for plastic/ rubber impeller and gaskets....
  11. A

    Impeller replacement glycerin and grease

    When ever I need to lube rubber material products or O rings, I reach for Dow 111 valve lubricant. Easy to find and specifically made for rubbery stuff. It is a very sticky silicone lube, is not easily flung off, and is good for these types of material. Used this stuff for over 30 years and...
  12. A

    Starting a 1974 Tri-Hull Restoration, it's a Stryker Mark IV model. Need help with any information or an owners manual.

    OSB gets wet then crumbles without being sealed thoroughly ! Did you check structure for wood rot ?
  13. A

    How do I drain my fuel line?

    I drain the extra fuel out of my fuel line at the end of each season. I hold the motor connector high in the air then release the ball in the fitting. Also squeeze the ball to get rid of fuel in the line. Most runs back into the tank, but hold the line outside the boat so any fuel squirting...
  14. A

    Boat sitting in slip caught fire, then set this one on fire

    Once fiberglass ignites, it continues to fuel the fire, kinda like throwing gasoline on a fire. Another reason glass boats are costly to insure.
  15. A

    How should propeller “leakage / water seepage at the shaft seal” be addressed?

    What type if boat and mfgr.....what drive ? Lots of different inboards over the years....
  16. A

    Brake based limited slip differentials

    We have nice ramps for the most part, but having a good quarter inch of green slime covering the ramp for the length of your tow vehicle makes the nice ramp not so nice. Steepness is a big factor, I have watched big dual wheel trucks burning rubber trying to pull 6K boats up these ramps, each...
  17. A

    Brake based limited slip differentials

    I only use 2wd on most retrieval, but the 4wd is there if needed.... and it has been needed on a few ocassions!! Water has been low this season, really low this fall...ramps are like ice, many can't get traction with 4wd...at season's end we are seeing a number of folks using two vehicles to...
  18. A

    Brake based limited slip differentials

    I would never use a two wheel drive on a slippery boat ramp with a 4K boat, that is an accident looking for a place to happen......
  19. A

    2018 Yamaha 40 HP, Poor top Speed

    Needs to go back to that dealer as the problem is NOT fixed !
  20. A

    Should I use a kicker when trolling in a 4.3L Mercruiser?

    On Lake Erie, I have found that I get more bites when my boat wanders a bit. Pure straight runs gets fewer bites. I look at a kicker motor as a safety device. Never had to be towed in 60 plus years...knock on wood..in the event of engine failure, the kicker has always taken me back to the...
Top