Search results

  1. Larry E

    Ignition switch or what?

    I got my neutral switch installed and WALLA the motor turns over like a champ. But wait a minute it will not stop cranking when I release the key. I have to disconnect the battery to stop it. Then when I hook the battery back up it is OK till I turn the key again. Ignition switch or slave...
  2. Larry E

    HELP I need to find this neutral switch

    I need to find a neutral switch for my OMC throttle (see pictures). The ones I do find are out of universe costly like $299 (are you kidding me?)I have a part number which is 172123 on the switch, and 980798 on the throttle. Any help appreciated... Larry E
  3. Larry E

    Motor height adjustment

    What is the adjustment necessary for the front of a GM 2.5 motor. I know how to do it just not sure where it should be initially. Thanks Larry E
  4. Larry E

    OMC tilt mechanism

    Not sure if this is the right place to post this but here goes. Got the new transom seal installed so now I am moving to the tilt mechanism. I have a new motor, new hammer coupler but the tilt worm gear will not move. I removed the motor and put a screw driver to the mechanism and it will not...
  5. Larry E

    Transom seal replacement

    I am going to be replacing my OMC transom seal tomorrow. What kind of sealent should I use between the rubber and transom? Larry E
  6. Larry E

    Weird hole under floor leading into bilge area

    On my 1974 Seaswirl there is a hole that is under the rear edge of the floor and leading into the bilge. At first water came out of the hole after I removed the glob of silicone someone had plugged the hole with. Is this hole supposed to be there or is it supposed to be plugged? Thanks Larry E
  7. Larry E

    Throttle Assy needed

    I need this throttle control assy for my 1974 Seaswirl Ranger 16 foot. I do not need the cable assy. If you can help let me know EDIT Thanks Larry in Creswell Oregon
  8. Larry E

    Help with dash board wiring

    I am presently restoring a 1974 Seaswirl Ranger with OMC and GM 2.5 motor. Prior to me buying the boat someone tried to rewire the dash board and did not get things back where they were. Would it be possible for someone reading this to take a picture of the wiring on the back of the dash if you...
View older results
Top