Search results

  1. S

    J90ELEDR Cooling Concerns

    You don't need to pierce the wire in there. You slide your pick in-between the wire and the wire cover until you hit the metal connector. I would think the sensor would ground out internally not in the body of the sensor but I could be wrong. Did you check both sensors?
  2. S

    J90ELEDR Cooling Concerns

    I believe your incorrect. Same block and it's the newer style with the round plastic access covers with a o-ring. Other style is at the back near the bottom of the engine.
  3. S

    J90ELEDR Cooling Concerns

    If you go to the 5 minute mark of this video it should show you everything.
  4. S

    J90ELEDR Cooling Concerns

    Shove a metal pick down into the tan wire under the clear or black rubber cover coming from head sensor. Ground it to a head bolt and see if your alarm goes off. I'm betting your sensors are bad because your temp readings are to hot. The orientation is a no brainer on this....shows it clearly...
  5. S

    J90ELEDR Cooling Concerns

    Can't really answer your question but if you're running that hot and your alarm is not going off you have something wrong and the alarm system. Is the control box horn giving you one beep at startup? Otherwise test the sensor on the heads.... Easy to do. I'm surprised you can keep your finger...
  6. S

    115 Etec gearcase assembly

    Seaway marine in Lynnwood Washington also has tons of parts.
  7. S

    115 Etec gearcase assembly

    Barnacle Bills trust me...no better place.
  8. S

    115 Etec gearcase assembly

    Go to Barnacle Bills Evinrude web site. Best etec info on the Internet.
  9. S

    1989 Johnson 30hp Question

    Try to make it happen while you're shooting a video. Videos turned to YouTube videos are easy to do and work well on this site.
  10. S

    96 Johnson 28SPL lower unit interchange?

    Plugs, gear oil, impeller, triple guard grease....maybe a fuel pump diaphragm, fuel lines, primer and paint. Seaway marine should have everything.
  11. S

    25hp Johnson outboard

    I just see an old gasket and exhaust build up. Assuming the GC is off, spray break cleaner in there, clean it up nice and install a new gasket.
  12. S

    97 evinrude 70hp misfire and wont idle

    Yeah, seems sketchy. Post your model number so we know what you have. Any videos of it running? YouTube's are easy to make and send. What other diagnostics were done?
  13. S

    25hp Johnson outboard

    What part are you referring to.... https://www.marineengine.com/parts/johnson-evinrude-parts.php?year=1972&hp=25&model=25RL72R&manufacturer=Johnson&section=EXHAUST+HOUSING
  14. S

    2000 Johnson 60 HP

    You say "good compression" may I ask what those number are? And did anyone do a spark jump test? Sounds fuel related but you never know.
  15. S

    Manual Tilt Lock Kit?

    You know I'm not really sure but probably! 🤣😆🤣
  16. S

    Manual Tilt Lock Kit?

    And a bungee cord
  17. S

    2000 Johnson 60 HP

    From I boats purgatory....😆
  18. S

    2000 Johnson 60 HP

    And yes folks, it seems I'm back!
  19. S

    2000 Johnson 60 HP

    Do you have the original 60 HP carbs?
  20. S

    Warning buzzer issues 1995 E90TLEO

    When I bench test a horn it only works one way. Must be a diod. Wire from the sensor is the ground. The horn part that I listed is the correct horn for your motor.
Top