I recently purchased 1986 Chris Craft Cavalier 17ft. It's a 3.0 with OMC outdrive. The second time I took it out it started dying when I took it in and then I had a hard time keeping it running and putting back in gear. I read about the ESA switch and found the switches. The ESA switch will kill the engine if I click it. RPMS seemed a little low so I gave the idle screw a 1/2 turn so it would run while in neutral and today it ran and allowed me to put it in forward. Ran fine in no wake zone and then kept stalling when I tried to accelerate.
Seems like a fuel problem, and I can't find fuel filter. I found fuel pump and took off "bell looking housing" and there is no fuel filter under there.
Ideas? It ran fine when I test drove it and basically fine a few other times. Very frustrated.
Thanks. If there is a fuel filter please post a picture. Or point me in the right direction. Bill
Seems like a fuel problem, and I can't find fuel filter. I found fuel pump and took off "bell looking housing" and there is no fuel filter under there.
Ideas? It ran fine when I test drove it and basically fine a few other times. Very frustrated.
Thanks. If there is a fuel filter please post a picture. Or point me in the right direction. Bill