Had my new acquisition out on the water today. In neutral if you advance the throttle it sometimes blubbers but it usually revs up so fast you think it's going to blow. In gear the motor will not run at all mid throttle, low throttle to mid is working ok and I'd estimate I got maybe 4hp out of it.
If I drop the throttle to idle and then throttle up to the mid point a few seconds later the motor will spin up and give me an extra couple of hundred rpm for 5 to 6 seconds before dropping back down to 'normal'.
I'm thinking some bugs or something got inside and blocked the high speed orifice, any idea where it is in this carburetor? The parts diagram isn't very clear.
If I drop the throttle to idle and then throttle up to the mid point a few seconds later the motor will spin up and give me an extra couple of hundred rpm for 5 to 6 seconds before dropping back down to 'normal'.
I'm thinking some bugs or something got inside and blocked the high speed orifice, any idea where it is in this carburetor? The parts diagram isn't very clear.
