joe outlaw
Cadet
- Joined
- Feb 16, 2010
- Messages
- 7
I went out and tried the 115 carbs on the 85hp motor and they worked. The only thing I found to be a sore was when it would idle. It wanted to shut off. I played with the low speed needles like the fourm said and think I was close but not close enuff. In the fourm it states to turn them in an 1/8 at a time and the rpms would go up and to back the rpms back down. question is what do I adjust at that point to get the rpms down? I started out snugging them up then out 1 and 1/2 turns out then went on like the fourm said. what do I do then to get the rpms down. and that motor max rpms are 5000 It went up to 4600 which is fine with me because it was moving around 35 mph.any suggestions?