ok...so I had my carbs rebuilt...got the motor running pretty good...fires right up now...decarbed the motor, tested spark and compression etc....except goofy me...somehow i flipped the carbs around...the carb with the cam roller is on the bottom...i took off the cam roller before I knew what was going on. Anyways, I need to flip my carbs back around tomorrow, and put the cam roller back on. Now that I have taken it off....how easy is it to get it placed back correctly and get my cam roller aligned correctly?
Also, one of my cables shifter , etc had the little thumb screw turned some when the cables were unbolted from the retaining clip area on the air silencer housing. How do I adjust these back to where they go. Any tips would be great. Now that the motor fires and runs great, id like to get this thing set correctly and get it in the water!
Also, one of my cables shifter , etc had the little thumb screw turned some when the cables were unbolted from the retaining clip area on the air silencer housing. How do I adjust these back to where they go. Any tips would be great. Now that the motor fires and runs great, id like to get this thing set correctly and get it in the water!