Beeping from throttle

[serverparis]

I have a 1994 Mercury 115 and when the key is on it beeps, it sounds like a trash truck backing up. I changed the oil tank and it still beeps. I disconnected one wire from the sensor in the oil tank and it still beeps. I diconnected both wires from sensor and it still beeps. I have bridged the terminals from the sensor, still beeps.the sensor ohms out as open. The only way i could get it to stop, was by disconnecting the ground wire from the module, where all these wires connect. The waterpump is working. I am just not sure if its getting oil to the gas, but it starts and runs good.

 

[LubeDude]

Re: Beeping from throttle

have you purged "ALL" the air from the tank under tha cowling? Losten the cap and run the engine at Idle untill a slight amount of oil leaks out, then tighten the cap and wipe excess oil off.<br />You didnt mention the year of the engine. This may only apply to the newer engines.

 

[serverparis]

Re: Beeping from throttle

I'm sorry, the year is 1994 and I changed it on the add. I have a manual oil pump and I did loosen the bleeder valve and let some run out. I am afraid to let it run too long, because of maybe no oil.Thank you!<br /><br /> In Gods Service,<br /> server

 

[serverparis]

Re: Beeping from throttle

serverparis@charter.net

 

[gss036]

Re: Beeping from throttle

Premix your fuel.

 

[serverparis]

Re: Beeping from throttle

I think I will start premixing the fuel, so now I just need to wire around the sensor for the oil, so the temp sensor will still work. Thank you for your imput!<br /><br /> In Gods Service,<br /> server