In this 93 crownline open bow, the left side bolster has
deteriorated under the vinly near the outer edge, below
the windshield. this bolster is very form fitted to the inside
of the bow, even wrapping around the area along
the dash in the walkthru. it seems very tightly connected to the
fiberglass behind it, especially the top edge where there is a
rib in the vinyl.
I haven't crawled under the dash to see if there are
screws and nuts holding it on yet, but the fact that it's
contoured so much concerns me. the boslter starts
up near the front most part of the bow, comes back to where the
windshield is, then towards the center and around the dash
console. only the corner near below the outside corner of
the windshield is bad.
any thoughts or suggestions?
deteriorated under the vinly near the outer edge, below
the windshield. this bolster is very form fitted to the inside
of the bow, even wrapping around the area along
the dash in the walkthru. it seems very tightly connected to the
fiberglass behind it, especially the top edge where there is a
rib in the vinyl.
I haven't crawled under the dash to see if there are
screws and nuts holding it on yet, but the fact that it's
contoured so much concerns me. the boslter starts
up near the front most part of the bow, comes back to where the
windshield is, then towards the center and around the dash
console. only the corner near below the outside corner of
the windshield is bad.
any thoughts or suggestions?