Determining correct thrust washer

[paw2000]

Hi, been searching past messages and haven't quite found what I need. I have a 88 125hp single (non thru hub) outboard. I picked up a used Michigan wheel 073009 SS propeller. I read thru several similar postings and I have a few questions. My original prop had an integrated thrust washer. The new prop fits the shaft, slides on no interference but it will need several thick washers to tighten. I'm thinking I need a thrust washer on the shaft first then prop. I haven't been able to find a part number. Do these washers come as a standard thickness?

I'm borrowing this picture (sorry)
http://i140.photobucket.com/albums/r10/dmaschi/DSCN2097.jpg

I will need a thrust washer, any suggestions for a part number?

 

[MWBROWN]

Re: Determining correct thrust washer

F523099-1 SPACER-PROPELLER from Crowleymarine.com $34.79

THere are diagrams that show most of the parts.

Good Luck,

Mike