exhaust manifold stud tightening tool

[Shaun78]

What do you use to tighten the studs into the cylinder head? I used vise grips. There is a center piece on the stud with no threads so I tightened it there. I'm glad that job is complete!!!!!!!!!!!!!!! (manifold/riser replacement) I will try to post a photo of the old parts if I figure out how.

 

[Haut Medoc]

Re: exhaust manifold stud tightening tool

Same here.....​

 

[Mkos1980]

Re: exhaust manifold stud tightening tool

I just make sure the threads are clean and screw them in by hand until it stops. I've never cranked on the studs. Thats what the nut is for.

 

[Bt Doctur]

Re: exhaust manifold stud tightening tool

you really want to avoid the vise grip route.just use 2 nuts jammed together on one end. also a good idea to clean the hole with a tap first.

 

[whywhyzed]

Re: exhaust manifold stud tightening tool

...

 

[rebars1]

Re: exhaust manifold stud tightening tool

I use double nuts jamed together. I torque the studs a little higher than the manifold nuts that will attach to them. Then the studs do not loosen when the manifold nuts are removed in the future.

 

[mstng]

Re: exhaust manifold stud tightening tool

How about a suggestion on removing the studs? Other way than vice grips?

 

[bomar76]

Re: exhaust manifold stud tightening tool

Could always try the right tool that is made for the job....
Craftsman Stud Remover $24.99
http://www.sears.com/shc/s/p_10153_...ssories&psid=FROOGLE01&sid=IDx20070921x00003a

 

[Don S]

Re: exhaust manifold stud tightening tool

Best not to post to an old thread with a new question. Besides you already have a post on this subject. Read the archives, don't reply to them or use them to ask a different question.