Flap bennet issue

[ste80]

Good afternoon, i hope the thread is in the right place

I've got an issue with my bennet flap pump.
When the boat was stopped 5 years ago flaps were working properly.
Now that i'm rebuilding the boat i noted that flap is not working anymore , it seams that motor shaft is blocked.
Does enyone know how to take in part this motor? Between motor and pump it seams there is a white glue and i can not open it.
Thanks everyone will help

 

[Scott Danforth]

the whole Bennett power unit isnt that much money. I would just replace the whole thing. the motor and pump combination were not intended to be serviced, hence the epoxy.

 

[ste80]

the whole Bennett power unit isnt that much money. I would just replace the whole thing. the motor and pump combination were not intended to be serviced, hence the epoxy.

Thanks, i sow something like 800€. Isn't it?

 

[Scott Danforth]

the whole system is less than 800€ the pump is about $200 USD (~ 175 euro)

contact them directly. dont try to buy thru the multiple middle dealers adding their margin on it.

amazon even lists the V351HPU1 https://www.amazon.com/s?k=bennett+v351hpu1

 

[ste80]

Thanks so much.

 

[ste80]

the whole system is less than 800€ the pump is about $200 USD (~ 175 euro)

contact them directly. dont try to buy thru the multiple middle dealers adding their margin on it.

amazon even lists the V351HPU1 https://www.amazon.com/s?k=bennett+v351hpu1

View attachment 408201

I try to contact them but they reply that i have to contact supplier in italy. I will try thuesday because today they are cloosed and monday is italin holiday . But i contacted another shoop where normally i buy all items here and the cost here is 695€
Or i'll buy a used one or i need to buy in usa (there i sow is for 150/200€) i dont know if they swim to bring from usa to europe to increase the price more then 3 times