front hatch needs riser arms replaced

[ericcarr2000]

Ok, I have a 1990 sundancer that I need to replace both of my riser arms on my front 20 X 20 hatch. Does anyone know where I can find a pair of these located at?
I do know that part number 1724 states that it is for the 10 X 10 hatch but it looks exactly like the one I need. However the part number 1722 states that it is used for the 20 X 20 hatch but doesn't look like the one I need. Can anyone on here maybe measure the part number 1724 for me with it fully extended and let me know what the measurement is? It would be greatly appreciated.

 

[ericcarr2000]

The measurement I need is 21 1/2 inches fully extended and 13 inches fully collapsed.

 

[thumpar]

Pull one off and take it to an auto parts store. It is not just length you need to worry about. The pounds rate needs to be the same too.

 

[JASinIL2006]

These guys were were very helpful in getting me replacements that matched my old ones:

http://www.spdhardware.com/catalog/GSNI Black Nitride Shaft Gas Spring

 

[ericcarr2000]

Mine aren't gas springs or anything like that. Just simple turn knob adjustments.

 

[alldodge]

Mine aren't gas springs or anything like that. Just simple turn knob adjustments.

Something like this

 

[ericcarr2000]

Kinda, mine has some sort of a cam at one end of it. Mine looks like part number 1724 but it states it's for a 12 X 12 hatch.

 

[The Great Escape II]

Who made the hatch? Possible Taylor Made, if so contact them.

 

[3rdtimesthecharm]

West Marine may have them.They did a few years back.westmarine.com

 

[ericcarr2000]

Yeah I've contacted taylor made a few times now and the one I actually need they don't have anymore...