Scotty's Fujiboat
Petty Officer 3rd Class
- Joined
- Jun 24, 2005
- Messages
- 93
My 20 HP johnson had a bad coil, so I went on Ebay & got a whole set up.(from a 6 HP) Plate, coils, points, condensers... Alls I had to do was swap throttle lobe and install the whole setup.Well, the old set had wires comming out from underneath for a kill switch. This set does not. Is there any way to rig my own without to much effort? (like buying different coils) To shut it off, i turned the idle screw back a few turns. This way when i back down on the remote control all the way, it shuts it down. I know this can't be a good thing for my motor, So thats why I'm asking if theres a way to rig up a kill switch. I have a brand new one but dont know where to hook the wires (2) 
