tx90baylinercapri
Cadet
- Joined
- May 4, 2012
- Messages
- 8
How in the heck did that happen??? If you are cheap then drain it, clean it well with rubbing alcohol, sand around the area lightly, and JB weld it. However, the proper way would be to weld it. Any good marina could put a small weld on that in a few minutes.
That does look like the impact hole for the speedo.
Its in the right location anyways.
Where does your speedo tubing hook up to?
Year of your outboard would be most helpful.
sorry, its a 1990 90hp force outboard.
I did notice it after i removed the gearcase cover because the there was a crack in the plastic gearcase cover.
So is that hole suppose to be there?
