My wife and I bought our 1988 Invader V210 Cuddy cabin last year in July. She ran pretty darned good for the last half of the season. I searched this forum high and low for just about every tidbit of information that I could about winterizing, prop selection, and so on.
I knew the boat would need bellows, so I dove in. Ordered a wide variety of parts from Amazon with the many gift cards that were given to me over the last 6 months.
I tackled the impeller this morning, and set about to remove the bellows this afternoon. In the process, I accidentally smashed the starboard trim sender. I finally found the tip on the forum here for S bending a wrench so that i could get the 2 bolts out that holds the retaining plate where the wires go through the boat.
So thanks for all of you hard earned tips, tricks, and information that you have been generous enough to share with the world!
I knew the boat would need bellows, so I dove in. Ordered a wide variety of parts from Amazon with the many gift cards that were given to me over the last 6 months.
I tackled the impeller this morning, and set about to remove the bellows this afternoon. In the process, I accidentally smashed the starboard trim sender. I finally found the tip on the forum here for S bending a wrench so that i could get the 2 bolts out that holds the retaining plate where the wires go through the boat.
So thanks for all of you hard earned tips, tricks, and information that you have been generous enough to share with the world!
