motor guide 109 # tour edition

[andymorrow]

on the chip board need to know how to wire the pot wires red , green , black on the 6 pin insert plastic piece that attaches to chip board.

 

[Silvertip]

Re: motor guide 109 # tour edition

After reading this a couple of times I have come to the conclusion that:
1) chip board is not particle board but rather a "circuit board"
2) the plastic piece is a "connector"
3) pot is a "potentiometer"

As to how it is wired -- I have no idea. But a call to MotorGuide might produce a wiring diagram or an on-line search might produce one as well. I will also assume that you removed something to replace something so why not put it back together the way it was?

 

[andymorrow]

Re: motor guide 109 # tour edition

After reading this a couple of times I have come to the conclusion that:
1) chip board is not particle board but rather a "circuit board"
2) the plastic piece is a "connector"
3) pot is a "potentiometer"

As to how it is wired -- I have no idea. But a call to MotorGuide might produce a wiring diagram or an on-line search might produce one as well. I will also assume that you removed something to replace something so why not put it back together the way it was?

dont remember how the wires went

 

[John_S]

Re: motor guide 109 # tour edition

Try looking through here for a schematic: http://www.mikesreelrepair.com/schematics/index.php?cat=59

 

[andymorrow]

Re: motor guide 109 # tour edition

Try looking through here for a schematic: http://www.mikesreelrepair.com/schematics/index.php?cat=59

i did it didnt show me the hook up.thanks