No power to starter or tilt

[degoude]

Starter will not respond when ignition is turned. My tilt is also not responmding. I can jump the solenoids and start the engine and operate the tilt. I replaced the starter solenoid, but I have the same problem. Any suggestions?

 

[MikeV4]

Re: No power to starter or tilt

Check your wiring from the controls to the engine, may be the plug is corroded.

 

[JUSTINTIME]

Re: No power to starter or tilt

check key switch
emergency stop switch
neutral safety switch

 

[Boatin Bob]

Re: No power to starter or tilt

No idea what your working on or what year but normally both of those circuits are fused, not likely you've blown both fuses but possible. You need to check for 12v at the ignition switch and at the tilt/trim relays.

 

[Silvertip]

Re: No power to starter or tilt

There is a fuse in the engine compartment. It's blown. It will likely blow again so you'll need to figure out why? If you don't test, you'll continue to throw parts at the motor. Follow 12V. When you lose it you've found the problem.

 

[degoude]

Re: No power to starter or tilt

Starter will not respond when ignition is turned. My tilt is also not responmding. I can jump the solenoids and start the engine and operate the tilt. I replaced the starter solenoid, but I have the same problem. Any suggestions?

 

[degoude]

Re: No power to starter or tilt

Starter will not respond when ignition is turned. My tilt is also not responmding. I can jump the solenoids and start the engine and operate the tilt. I replaced the starter solenoid, but I have the same problem. Any suggestions?

d Thanks to all. It was the fuse.

 

[degoude]

Re: No power to starter or tilt

d Thanks to all responders. It was a fuse. I am up and running again.