Okay, as you can see from the pictures below I have some missing teeth. After doing some research, the part number that is on this actual part (332242) does not exist but the corresponding part number from Johnson/Evinrude is this: 397272. I figure this by eye balling parts diagrams. It's a common piece from the 90s to mid 00s and maybe later.
The problem is that they stopped making the part. This does me absolutely no good whatsoever. I don't want to have to replace the whole control box if I don't have to.
My thoughts are to use some kind of two part sandable epoxy to build these teeth back up. I have seen some pretty impressive stuff done with epoxy so I believe that this can be done.
What do you guys think? What material would you suggest?
The problem is that they stopped making the part. This does me absolutely no good whatsoever. I don't want to have to replace the whole control box if I don't have to.
My thoughts are to use some kind of two part sandable epoxy to build these teeth back up. I have seen some pretty impressive stuff done with epoxy so I believe that this can be done.
What do you guys think? What material would you suggest?
