Good evening gentlemen... what I have is a 1996 Johnson 150 Fast Strike on a 96 288 Stratos single console. I'm running a 14.5 x 24 Raker 1st gen. I have pretty good performance with this set up. Right around 60-61 mph @ 5500 rpm. I fish a lot of small lakes and the river which requires some low end performance, like staying on plane at low speeds. I did some research and picked up 4 blade Renegade Bass prop. Well little did I know that this was a V4 prop. 4" gearcase... I have a 4 and a quarter. I'm not concerned about the extra exhaust around the blades. I went up in pitch to a 25. So what no one can seem to tell me is, does evinrude make a thrust washer that fits the hub on that small tube prop and the propshaft of my V6 large tube gearcase. I am in the process of modifing a V4 washer now that the rep at the prop shop told me would work, but doesn't. Part # on that washer is 127084 or in some searches add a zero to the front. Any light you guys could shed would be greatly appreciated. I forgot to mention when I received the Renegade the hub was spun. I'm pretty sure it already had a converted hub, but if it didn't it does now. To except the V6 prop shaft. Thanks again.
Last edited: