parts needed 9.2 hp Chrysler

[fishnman101]

I have a 66 or 67 Chrysler made Wizard 9.2 outboard. Tuned the motor(runs great)but found out my driveshaft is broken where the pin goes through for the impeller. Is there a used shaft out there and can i still buy an impeller for this motor? Looks to good and runs too good to throw away! What am i looking at $$$$$$. THANKS DENNY

 

[Frank Acampora]

Re: parts needed 9.2 hp Chrysler

It probably is the same shaft as a Chrysler 9.9 or early Force 9.9. You need to know if the engine is short shaft (15 inch) or long shaft (20 inch) This refers to the length from the engine mounting clamps to the cavitation plate, not the drive shaft length. Yes, impellers are still available--old outboards or franzmarine@aol.com

New? you don't want a drive shaft--probably one hundred or more. Look for a cheap junker or on ebay. lacking that, send me a private message. Waterpump impeller between 17 and 27 bucks.