Plumbing Diagram Will it work?

[wildmaninal]

I drew this up with the intentions that it will work. What do you all think? Some of you all helped me on the new to boats need help on wiring post, and I got allot of good help from everybody and I thank you. The bassperator for the live well is currently installed by the plug for the boat, didn't like the idea of drilling another hole in the transom. I figure that the boat was setup with a submersible live well pump only were you had to pull the plug to fill the live well. I am trying to set it up with a sprayer bar using hot water PVC and drilling small holes in it along the length of the pipe capping each end off T'ing it in to run it out the back of the live well at the top. I would like to add a overflow pipe to the livewell can I T in to the pipe going out the side of the boat, will it be gravity fed or not (this is not showed in the diagram)? This diagram that I posted will most likely need to be zoomed in on to get a better look at it.

 

[wildmaninal]

Plumbing Diagram enlarged

Plumbing Diagram enlarged

You should be able to make this one out better, still might need to zoom in. The other one was blurry.

wildmaninal

 

[tashasdaddy]

Re: Plumbing Diagram enlarged

Re: Plumbing Diagram enlarged

attwood, makes the same thing.

 

[wildmaninal]

Just thought of something

Just thought of something

If I run the live well bilge pump at the same time of the aerator, I shouldn't half to worry about the overflow pipe right? The aerator is 450 GPH and the bilge is 500 GPH. That was a duh moment .