My 2001 Yamaha 115 power trim crapped out. I figured this was coming as it has been leaking hydraulic fluid. That tells me the seals need replacing. I filled it back up with fluid hoping that I could at least get it to trim up and down and still no go. It's stuck in the up position. The trim motor runs but it's not moving the rams up or down.
Do I need to bleed air out? How?
Is it not compressing fluid because the seals are that worn out?
Does any one have a tutorial on how to replace the seals? That sure would be helpful.
What special tools are needed?
Thanks,
Do I need to bleed air out? How?
Is it not compressing fluid because the seals are that worn out?
Does any one have a tutorial on how to replace the seals? That sure would be helpful.
What special tools are needed?
Thanks,