Remote Control Tach question

[zach103]

i took a look at this site and right now i have the gray wire running from the remote to the actual guage. than the ground and one connected to the buzzer are both hooked to the remote but no where else.. should i just leave them or were can they go?

http://continuouswave.com/whaler/reference/ignitionSwitch.html

 

[emdsapmgr]

Re: Remote Control Tach question

Some of the very early control boxes only have a grey signal wire. If you only have a single grey wire-it goes to the S terminal on the tach. In those cases, I prefer wiring the + and - electrical source that drives the other gauges on the dash. Later boxes have a pigtail with three wires, the grey, pink (pos) and black (ground) for connecting the tach. You can decided if you want to hook up the light in the tach.