Could a shift interrupt switch cause hard starts under load? What about lack of wot rpms? I've been doing a ton of research and it seems likely that a faulty switch or improperly adjusted cable could be causing my problems. We recently replaced the control cables and shortly after the problems began. Any tips on adjusting the shifter cable so that the switch works propperly? I have another post regaurding my problems but I'll list them here as well. Any advice, opinions, or ideas would be appreciated.
-On the hose motor seems to perform properly
-Intermittent starting problem on the water
-When motor does start I have to put it in gear or it will die
-Motor wants to stall out while shifting into gear
-Can't reach top wot rpms(lucky to get 5000 when it use to hit 6000 with ease)
-On the hose motor seems to perform properly
-Intermittent starting problem on the water
-When motor does start I have to put it in gear or it will die
-Motor wants to stall out while shifting into gear
-Can't reach top wot rpms(lucky to get 5000 when it use to hit 6000 with ease)