tilt switch??? OMC 1978

namstarfire

Cadet
Joined
Apr 27, 2010
Messages
6
1978 OMC 235 stern drive. stern drive stuck at down position. took apart tilt system found out tilt shaft broken. replaced tilt shaft - o rings - gasket. put everything back together. sanded down connection for solenoids and reconnected. flick tilt switch up and down still making a clicking noise only.

do anyone know if the solenoids or relay or 50 amp fuse is bad?
 

pete s

Petty Officer 2nd Class
Joined
Mar 4, 2010
Messages
112
Re: tilt switch??? OMC 1978

if the solonioids are making noise then your fuse is good, sounds like you have a motor issue. Check for power at the motor with the switch up or down also check for proper ground. On the sticky thread there is a link to download the manual, I did this and it is very helpful as I have the same set up you do.
 

Howard Sterndrive

Rear Admiral
Joined
Nov 5, 2008
Messages
4,603
Re: tilt switch??? OMC 1978

if the solonioids are making noise then your fuse is good,.

The relays would click with the 50A fuse open
the 50A fuse only feeds the heavy circuit for the tilt, not the relay trigger

do anyone know if the solenoids or relay or 50 amp fuse is bad?

? not sure what you are asking

you should check the 50A fuse and clean it with some steel wool or emery cloth
you can get those fuses at car stereo shops and here is a schematic (older year but similar)
http://hhscott.com/evinrude/images/wiring/73_OMC_V8_all_big.jpg
 
Top