dlogvine
Master Chief Petty Officer
- Joined
- May 4, 2015
- Messages
- 839
I dropped a new, or better said newly rebuilt 1993 v8 305 Mercruiser, into a 2006 Baja Islander 202 boat. Just got it running last night. The old engine did not have a gear lube monitor, but a newer outdrive and the gimbal housing have a setup for the gear lube monitor, which I installed. Now I have the control wires from the monitor that need to be connected but I'm not sure where should I hook them up to. I know it should be a simple task but instead of digging through a ton of wires in my other boats harness to find where does it go, I think it would be faster just to ask. Thx.
by the way this baja boat turns out to be a great project, I reupholstered everything except the captain's seats and am working now on the final parts of the engine compartment, and then will finish with a new layer of fiberglass. the boat I got at the beginning was a hull with all controls and gimbal, no engine or outdrive and most of the upholstery dead.
by the way this baja boat turns out to be a great project, I reupholstered everything except the captain's seats and am working now on the final parts of the engine compartment, and then will finish with a new layer of fiberglass. the boat I got at the beginning was a hull with all controls and gimbal, no engine or outdrive and most of the upholstery dead.
