Working on a 1989 mariner 30M
Starting to clean the carb. What is this small hole for ( screwdriver pointing). It doesn't line up with anything on the carb body side. Also the big hole on the edge of the bowl is closed off once the gasket is on. I blew air in both of those holes and it didn't...
2000 yamaha 130 hp. Possible to remove trim unit with motor bolted to boat? I got the upper pin out and the unit moves away from the transom but is there enough room to pull the whole thing out of there?
2001 130 hp . Mounted on boat. Any tips on how to replace the trim motor without removing the engine from the boat? I know I'll have to use the release valve to tilt it up and put it on its tilt lock.
I just checked it out. I disconnected the motor wires and ran power to them. I can get the motor to spin briefly by tapping on the body of the motor. Safe to say it's the motor?
I have a 2001 130 v4. I put an aftermarket trim motor on it last season and it worked OK for the few times i used the boat. Now it's not working. I hear the relays click but the motor won't operate up or down. I'm planning on keeping this boat/motor for a few more years at least. Should I buy a...
Picked up a 1995 evinrude 2 cylinder 2 stroke 30 hp. The port on the water jacket cover needs help. Previous owner silicone a tube over this brass port but didn't hold. It's only sticking out about 4 mm (.16"). The jacket cover bolts more than likely will break if I try to remove it. (Try to tap...
Question. If I apply heat directly to the metal part of the overheat warning switch (switch removed from cylinder head ) should I be able to sound the warning horn? Heat from a heat gun.
