Search results

  1. S

    Yamaha 50

    Got a call from a friend last night and he has a 1996 Yamaha 50 HP 2 stroke with a bum gearcase. (50ilhu) he picked up this 1994 40 HP and wants me to help with swap over the lower unit. Anyone know if these two motors aren't compatible? Let me know. Thanks, Matt
  2. S

    1977 Johnson 35hp neutral cut out switch question.

    Working on a 77 Johnson 35. 35el77c To make a long story short, starter would not crank over. Finally got it to crank by grounding the soloniod. Neutral switch on the other side doesn't pass ground through it. There is only 1 wire to it....the one that goes to the soloniod. Is there supposed to...
  3. S

    Johnson 30 carb issue

    Johnson J30TELCUB Pulled the carb off a friend's Johnson 30 hp and found this. Missing it's outer tube. Anyone know what that outer tube is called or does this year not have one.
  4. S

    Etec forum

    Anyone know if there is still a forum just for E-Tech owners? I used to go through e Nation but when BRP collapsed so did E- Nation. I joined up for Barnacle bills and I read posts but I couldn't find a way to make a post. There's some stuff on the hull truth but I ended up having the same...
  5. S

    Johnson 8 pusher prop

    Racerone or whomever, Outboard...J8SRLEDS so 1996 extra long shaft. This is the prop on it. Can't find any info on them and can't read the size. Stock paint seem to have covered up the markings under the cone. Didn't really see anything on the parts breakdown either. Let me know. Thanks
  6. S

    F4 water issue

    Hi, I have a 2000 Yamaha four horse four stroke. Doesn't seem to be peeing much water but runs fine, at least off the boat and in a tank. Do these motors not run much water out the telltales? Went ahead and pulled the lower unit thinking the water pump was spun and everything looked brand new...
  7. S

    1987 Evinrude 8 bogging down

    Another question for you. My 1987 Evinrude 8hp (e8rcud) is having some issues. That model is the one with a primer not a choke. Starts fine with one pull on the primer, idles good, rips around at high speed but when I start to slow down it bogs out and then dies and wont restart. When I pull the...
  8. S

    87 johnson 30 throttle help

    Hey All, I have a 1987 Johnson 30 horse on a 16 ft. Lund. The throttle cable that runs from a standard omc (red plug) side mount control box is popping off back at the motor. The engine has a small block on the port side off the engine that supports the adjusting block of the cable and then a...
  9. S

    yamaha t-8 tilt motor

    I have a 2004 yamaha t8 with power tilt. Took the motor cover off the tilt so I could clean up some rust and paint it (They call it the tilt stator) and one of the magnets came loose. Funny it was working prior to that. They want an arm and a leg for that replacement part anyone know where I can...
  10. S

    Johnson sail master

    Here is a head scratcher for you. I purchased a 1990 6 hp johnson sailmaster a number of years ago and it seemed to work fine when I bought it. Put it on my boat as a kicker motor and it had a lot of engine noise and didn't run very well. Stuck it in the garage and didn't really look at it again...
  11. S

    1977 evinrude 35 hp

    Hey everyone, Helping my neighbor with his 1977 evinrude 35 horse. Fixed most stuff and cleaned up some stuff someone else messed up. Running good. Removed the bolts and nut that hold the gear case on so I could pull it and change out the water pump. Anyone know where to undo the shift shaft on...
  12. S

    03 yamaha t8 4 stroke

    I have a 2003 yamaha t8 four stroke that starts and idles fine but when you throttle up it bogs down. I thought dirty carb so I cleaned it twice and the same thing happened. Fuel pump is fine with 4 lbs of pressure. I put a new coil on it and still the same. A friend of mine had one he wasn't...
View older results
Top