When is coming out this hole and also the other side. Where would that oil be coming from?
Oil does not leak with the outdrive trimmed all the way up. Took me awhile to find where it was leaking. I did a pressure check and held pressure for thirty mins with no loss of air. Should I do seprerate...
I'm new to bayliner. I see that it has some sort of ecos, but how does it work. The boat did not come with lanyard. All I see is a way to flip the switch up to run and down to turn off.
Thanks
Volvo Penta I/O & Inboard Gas Engines & Outdrives
Volvo Penta wiring change
Thread starterllewis01
Start dateMay 6, 2021
Unwatch
L
llewis01
Seaman
May 6, 2021
Add bookmark
#1
I have a 1994 volvo penta 454. I'm changing the alternator to higher amp. My old alternator is a presolite 5 wire...
I have a 1994 volvo penta 454. I'm changing the alternator to higher amp. My old alternator is a presolite 5 wire and changing to a 3 wire alternator. My question is what the wiring diagram should be to do the change? I need the higher amp alternator to power all of my electronics.
Any help...
I'm changing my raw water pump on volvo penta 7.4 to a crankshaft pump that is a johnson f6b-9. With it mounted to the crankshaft, which port is the in port? It is a single engine which is right rotation.
Thanks'
I have a 1994 albemarle 265 with a 7.4 gm motor. I have problems with it starting. I have replace the ignition twice with new ones and replace the starter. Sometimes it will start when keep turning the ignition on and off about a does times. It will start every time when you jump the wire at the...
A few years ago I install new manifolds that would allow me to totally cool engine and manifolds to cut down on rusting out. The boat is a 1994 Albemarle 265 with a 454. Since Albemarle does cool the manifolds I went a heat exchanger for a Merc. As in the pic you can see how I did it. My problem...
i have a volvo dp 290 c1. I need to replace the complete u-joint assy in the upper bearing box. My question is do i need to replace the crush sleeve or can i just leave it and replace the u-joint assy?
I have posted on this issue before. The guy who rebuilt the outdrive has gone out of business. I was hoping he could help me with this. The grind going into to reverse and forward but it is ok when when it is finally in gear. Also I don't like how easy the clutch dog is when you manually switch...
I just had my 1994 volvo penta dp-d1 rebuilt. Justed it up yesterday to test it out and notice something strange. Now when going to forward or reverse it will grind for a sec before going into gear. Before I would get the thump going into gear. Ant suggestions on what could be the problem? This...
