Search results

  1. alldodge

    Volvo diagnostic port

    That is a new one, like VP messed up the harness and used the wrong connector
  2. alldodge

    what ignition system

    There are some but not all Look in the stickies and there is an area for manuals that are available
  3. alldodge

    2008 Glastron GXL 235, new 5.7 Mercruiser engine, bogging at 3000rpms

    The blower isn't the issue but does need to be fixed for safety. The antisiphon valve could be the issue or maybe a weak fuel pump
  4. alldodge

    Volvo diagnostic port

    You have the correct Rinda connector, you just haven't found the matting one on the motor. It's there somewhere The square one showing is the CAN buss connector
  5. alldodge

    Vovo Penta 5.0 osi

    Your motor has 2 oil pressure sensor. One goes to the gauge at the helm. The other talks to the ECM. Need to scan the motor but I think the ECM oil sensor might be the issue
  6. alldodge

    Engine Swap

    The engine coupler is attached to the flywheel LINK can be either item 4 or 9 Look at the splines inside the coupler to make sure the teeth are square and not rounded. The outdrive drive shaft goes into the coupler In most cases I would just replace it unless you know it's not very old. If...
  7. alldodge

    what ignition system

    By the way, have you run through the TBV troubleshooting guide?
  8. alldodge

    what ignition system

    Serial number 0F765981 is manual 17 covering 305 and 350 1993-1997 Part number 8232251
  9. alldodge

    Engine Swap

    Check/test and maybe replace the bilge pump Maybe the trim sensors Inspect the Y-pipe, Engine coupler, gimbal bearing, top steering pin, lower shift cable
  10. alldodge

    Unusual Bilge pump power issue

    There is corrosion somewhere and could be on the wire, wire connections or inside the float
  11. alldodge

    Trim pump wiring help

    Welcome I'm having a hard time understanding just how you have it wired
  12. alldodge

    Starter issue

    For me it still looks like a full rebuild Need one piston but doing one suggest do all Heads and everything
  13. alldodge

    Time to replace tires?

    I have them on my car trailer, and had them on my cruiser trailer when I sold it. Their still made and can still be bought
  14. alldodge

    Flushing out cooling system after sucking in mud

    If the check balls get stuck open the motor will start to get hot because the balls are bypassing to much water. The check balls are for draining only Could remove and flush but other than that I don't know
  15. alldodge

    Time to replace tires?

    I like/dislike bias ply heavy duty Like 6 and 8 ply bias ply ties. Four ply is all that's needed so much heavier and last long time with no steel belts to break from sitting long periods in one spot Dislike bias because when cold there is flat spots, but I've gotten mostly use to that
  16. alldodge

    Starter issue

    The cylinder stopped at TDC and is wedged Now that the head is off, trying to rotate the crank should be easier
  17. alldodge

    350 Magnum Tournament Ski spark plugs

    I would use what's on the arrestor Brought your serial number up again and it list service manual 8232251 which is number 17 for 305/350 1993 to 1997 printed 1996 My manual list your serial number and also list what I mentioned above
  18. alldodge

    Starter issue

    my wow was to the OP, not your statement
  19. alldodge

    Starter issue

    Wow
  20. alldodge

    Flushing out cooling system after sucking in mud

    Most likely the quad will be ok, but the bad part is if they are damaged I'm not finding them in the parts list. It only shows the entire hose assembly If they were damaged could most likely find them at a NAPA store I think you have done a good job of flushing it out. I would think about...
Top