Search results

  1. alldodge

    Not so welcome anymore....

    For the most part we all need a thick skin, and need to think before responding All forums change over time and there will always be ones that believe they are Gods gift and will bang on the table until you stop responding or agree with them. Along with ones that holler Squirrel and leave...
  2. alldodge

    27PC - motor/pump sound from bow

    It's probably the relay and you need to remove the head board to get at it To verify before doing it, go to the engine room on the port side above the Batteries and trip the windlass breaker I use to own a 27PC
  3. alldodge

    BMW headlight . . . $1,000 !!!

    Hey Ted just thought, what about junk yards? I'm sure there are a couple of these in a yard somewhere that might be had
  4. alldodge

    BMW headlight . . . $1,000 !!!

    Guess we all should look into cost of parts before buying, and with current T-word most will not be able to determine at this time
  5. alldodge

    Replacing my power block

    It's all based on max amount of amps (load) that may be needed. Look at the size wire that's feeding the current block and how long a run from the Battery it is. Then add up max load of each device
  6. alldodge

    Mercury Quicksilver 861925t 3

    That is a MEFI-4 conversion kit It takes a MEFI-3 and converts to a 4 and as seen it's NLA Have 3 options Try to find a used one that has been repaired See if your old only can be repaired at a place like OBD Diagnostics Or look on places like offshore only parts wanted
  7. alldodge

    BMW headlight . . . $1,000 !!!

    The headlights are like a double pane window, sometimes the seal leaks Remember my Ram HL was about $700 and I replaced. Found a youtube vid to show me how. Hope yours is easier
  8. alldodge

    Boats from work.

    bummer
  9. alldodge

    Illegal or not???

    It mostly depends on your state and insurance company Here is a good explanation LINK post 42
  10. alldodge

    Engine height

    Good point Jim Take a pic of the stern of the boat
  11. alldodge

    Boats from work.

    Nice
  12. alldodge

    Engine height

    Welcome Need to most likely rebuild the trim system, it's leaking internally I would start with the trim cylinder(s)
  13. alldodge

    Switching from trailering to storing in a saltwater slip... what is a "must do" to protect bravo3?

    With boat connected to shore power use a digital meter and connect Negative to battery ground. Connect the positive side to something like the mercruiser PROBE . Meter should read between Salt, Polluted or Mineral Laden Water Areas: 750 - 1180 Millivolts with Digital Meter
  14. alldodge

    4.7 million dollar boat has 12 person capacity at 63 feet? And then...

    Only if he was charging, if just a guy with a lot of money he doesn't need a lic
  15. alldodge

    mercruiser 454 MPI Horizon stalling

    Vacuum should be around 14 in Hg but boats are normally lower, never have figured that one out Timing setting should be close to 1800 rpm
  16. alldodge

    farymann 18W ( generator engine ) white smoke

    With a diesel my guess it's unburt fuel, because if it was water there would expect to see bent con rods
  17. alldodge

    Hinge pin

    Thanks was thinking Gen 2 and being a 2000 it is The part is item 30 in LINK for use with trim sensors in addition to the fiber
  18. alldodge

    mercruiser 454 MPI Horizon stalling

    A Horizon should be manual 23 The IAC moving in/out whit initial key on is one test, but may still be an IAC issue The 454 should not have adjustable rockers, it's torque to 40 ft lb Need to set timing Check vacuum
  19. alldodge

    Hinge pin

    There should be a fiber washer on each side between gimbal ring and bell housing What year is the boat?
  20. alldodge

    MerCruiser MCM 165 Trim Sender Wire

    All good, will try and explain until you understand Your drive does not have the senders mounted which means your drive does not have the capability for the trim gauge. Even if you have a brown/white wire at the helm, the option for it can not be added without replacing the transom assembly...
Top