Search results

  1. Scott Danforth

    Boat budget question

    Isnt AC a forensic accountant?
  2. Scott Danforth

    new engine overheats

    assuming since the outdrive has the pump in it, this is an alpha unit. did you replace the impeller back in 2016, or yesterday? because rubber parts go off of calendar hours, not use hours. your 9 year old rubber could be deteriorating and you could be loosing vanes. are you getting 15 psi...
  3. Scott Danforth

    A wiring question

    ABYC recommends 18 gauge, minimum not for capacity, however for strength 22 gauge can easily run 5 amps thru them, however in a lighting situation, you are only running about 3 watts. the 18 gauge you bought will be more than adequate.
  4. Scott Danforth

    New SeaRay owner (Sundancer 250) with some basic questions

    A Sundancer 250 with only a 5.0 is under powered. They were underpowered with the 5.7 magnum
  5. Scott Danforth

    2024 wake pro 230

    10 seconds with a refractometer and you will know the freezing point.
  6. Scott Danforth

    New SeaRay owner (Sundancer 250) with some basic questions

    I would just get tow boat US towing insurance. because iff things break, you will be a really really good distance from home.
  7. Scott Danforth

    NYC Accident

    the statement that I read was mechanical failure resulting in loss of helm control shortly after leaving the dock
  8. Scott Danforth

    Birds in the boat . . .

    Ted, may want to look at this crack in the plastic.
  9. Scott Danforth

    Alumacraft Livewell Valve Replacement

    Moved your thread to its own. please do not post in old threads. livewell valves are just plastic valves. they last about 15 years prior to needing to be replaced. to replumb most livewell systems, you must basically un-assemble the boat, removing all the platforms, etc., and in some cases...
  10. Scott Danforth

    cooking

    you are a geek.....
  11. Scott Danforth

    1987 Four Winns Boat 16ft inboard would you Buy?

    Start your own thread
  12. Scott Danforth

    New to Volvo family

    You want a spray out the muffs about 10 ft. You want to supply 7-10 GPM minimum to the muffs I use a 1" hose and 80psi (used to be 110 psi, until the county fixed the substation)
  13. Scott Danforth

    New SeaRay owner (Sundancer 250) with some basic questions

    The door stop is just HDPE (starboard). Contact your local plastics shop
  14. Scott Danforth

    New to Volvo family

    The issue is that idling in the water, the SWL is at least 8" above the crank centerline of the motor and the impeller is flooded On hoses and using muffs, you need more than 30-50 psi to get the water to the impeller. Use duct tape if needed
  15. Scott Danforth

    Birds in the boat . . .

    You may have to make up a surrogate for the ladder pocket when you move the nest. Then slowly move the surrogate away from the boat Did that when robins made a nest in my extension ladder when I lived in Wisconsin, and again down here in Florida with a cardinal nest
  16. Scott Danforth

    Vinyl Plank Flooring Installation Decision ???

    Shredded cheese or cheese sauce on the nachos?
  17. Scott Danforth

    Costa Coat

    Jack trailer and boat up. Block boat with cribbing, lower trailer. Will cost you about $40 worth of 2x6's and a box of screws to make cribbing
  18. Scott Danforth

    Hole shot

    Or 15x15p. The issue is getting that large drag load moving. You need a bit of slip to get the RPMs up, and a low enough pitch to pull the load. A single skier is a 400# load. A tube is up to a 2400# load if it submarines Since tubing is a 20mph event vs skiing at 30mph, I would most...
  19. Scott Danforth

    Gas/water separator filter

    Ha Ha Sounds like when I splashed I had the steering rack installed backwards..... Right was left .. made for interesting first splash
  20. Scott Danforth

    Vinyl Plank Flooring Installation Decision ???

    Joe, you assume it holds calibration. Ours is over temp one use, and may be under temp the next. We usually set the oven and adjust on the fly for each use
Top