Search results

  1. Bondo

    Should new gimble bearging gimbal? allow shaft to roll, pitch and yaw?

    Ayuh,...... It's supposed to move pretty hard,...... That factor allows us to align the drive to motor, 'n it to stay where you put it,... Cool video, by none other than my friend, 'n former Mod. here at iboats,.... Achris,.............:)
  2. Bondo

    Good spray on weed killers.

    Ayuh,..... Clorox Bleach,....... It kills everything it hits, 'n dissipates in no time,.... Used it for years to kill dandelions, 'n bamboo, that'll grow right through 2" of fresh blacktop in a couple of weeks,..... Dump abit of Clorox into the hole it forms, 'n beat the bump back down...
  3. Bondo

    350 Magnum Tournament Ski spark plugs

    Ayuh,...... Yer symptoms, 'n that plug says it's detonating, probably from a lean condition, or possibly to much timing,....
  4. Bondo

    Bravo 3 turns hard starboard underway

    Start a new thread of yer own, this one is an antique,....
  5. Bondo

    Volvo Penta 5.0 GL PWTR - severe overheat - thought I was on fire - troubleshooting Questions

    Ayuh,.... Nothing "Marine" 'bout 'em,.... Same as heads used on pickup motors, which are the same as standard production automotive motors,....
  6. Bondo

    best way to repair gimbal hing pin threads?

    Ayuh,...... Maybe, never tried it,..... To be sure, find a used freshwater used helmet,....
  7. Bondo

    need help identifying this steering actuator

    Ayuh,....... Welcome Aboard,...... My guess is, it's for a '99 Volvo SX drive,..... P/S actuators are pretty much all the same,.... hose attachments might vary abit,.....
  8. Bondo

    Outboard won’t trim down enough

    Ayuh,....... Goin' from a prop to a jet, you might need to cut down the transom to make it work,...... With the clutter in the picture, it's hard to tell,....
  9. Bondo

    Stuck again

    Ayuh,...... That's what I use,.... 6 point torque, insteada strippin' a 12 point tool,....
  10. Bondo

    Mercruiser 350 carb

    Ayuh,..... Backfires are usually from a lean condition, so go back, 'n attempt the rebuild again, fixing whatever ya screwed up the 1st time,.....
  11. Bondo

    Help me set up my new edelbrock 1409

    Ayuh,...... Just set it for 650/ 700 rpms, if it drops when in gear, in the water, readjust it then,...... My merc./ weber/ afb idles at 650/ 700, in gear or out, in the water or out,..... The only reason to detach the throttle cable is to make sure it's holding a slight tension against...
  12. Bondo

    Testing plug condition

    Ayuh,..... That'll tell ya whether that cylinder is firing,.... It won't tell you whether it's the plug, or it's wire,....
  13. Bondo

    93 mercruiser 4.3 alpha one gen 2 fuel problem (I think)

    Ayuh,..... Looks to me, to be the original Merc/ Weber/ Carter AFB,.....
  14. Bondo

    Alpha One Gen 2 Drive Shaft

    Nope,...... I know of no differences, unless the u-joints or something changed,.... but that's only a guess,.... Swapping drive for drive, all the Gen. IIs interchange,......
  15. Bondo

    Gas/water separator filter

    yes
  16. Bondo

    93 mercruiser 4.3 alpha one gen 2 fuel problem (I think)

    Ayuh,...... Then I'd suspect the contents of the fuel tank,.......
  17. Bondo

    Not so welcome anymore....

    Ayuh,..... Dam Newbies,........ :rolleyes::cool:;)
  18. Bondo

    93 mercruiser 4.3 alpha one gen 2 fuel problem (I think)

    Ayuh,....... Welcome Aboard,........ On the bottom, Where,..?? If in the bilge, yer fuel tank is leaking, probably gas out, 'n water in,..... When you changed the fuel filter, did you inspect it's contents for water,..??
  19. Bondo

    SBC breakin time

    Ayuh,..... 15 or 20 hrs,.... 30 won't hurt,...
  20. Bondo

    Sealing the U-Joint Bellows watertight on an OMC Cobra

    Ayuh,..... I'm a Merc guy, I was just answering yer question,.... Never had the problem yer dealing with, just offering a thought,..... 'n Yes, I use either #3, or #2, pretty much daily,....
Top