Search results

  1. R

    1978 Evinrude 70HP- Trouble starting/idling/bogging under load

    You need to find the pads.-----That is why I mentioned it.----When you buy used from some suppliers you do not always get what you need.----Is this a 2 wire or a 3 wire motor ?----Do you have the proper wiring relays if 2 wire?----A solenoid if 3 wire ??
  2. R

    STAINLESS OR NOT

    In Ontario ---try ----King's propeller repair.----Many used stainless props.
  3. R

    Pre-emptive repair/maintenance to do on a used Evinrude 9.9?

    Looks like a 75 model.----Post the actual compression values here.----And yes, I would consider that as a parts motor from what the picture shows.----About $100 is what I would pay.-----Here I would do a complete teardown, top and bottom.----If all is good , a seal kit for lower unit.----Fuel...
  4. R

    1978 Evinrude 70HP- Trouble starting/idling/bogging under load

    Post pictures of the steel " thrust pads " that are bolted on your motor.
  5. R

    One more old Boat Rescue

    Bought a gallon of Varsol a while ago to clean motor parts.----Talk about sticker shock.----Listed at $35.00 CA
  6. R

    1978 Evinrude 70HP- Trouble starting/idling/bogging under load

    Not sure if you have to remove motor from the boat.----Do you have the " thrust pads " that trim rams push on ?
  7. R

    Gone but not forgotten

    And fading fast !
  8. R

    Gone but not forgotten

    Have a buddy that assembled his own " tractor / snowblower " 4 X 4 machine.-----Parts from various vehicles.-----Two transmissions . one from a tow truck to get live PTO.-------Uses 2 clutches and 2 shift levers.----3 point hitch.-----Took the odd " sit-down " with a drink to look things...
  9. R

    How to test VRO system

    If there are wires coming from the VRO it has an alarm.------A factory manual has a test procedure.----I would not trust a1985 version of VRO.
  10. R

    Lake Decatur - good for boating & fishing?

    He speaks of a 24' boat likely draws 2 to 3 feet.------Just need to be careful or perhaps a pontoon boat.-----Fishing is always good.----The catching not so much in these crowded waters.
  11. R

    Lake Decatur - good for boating & fishing?

    If you can afford a 24' boat you can afford the latest in electronics.----Get a GPS / moving map unit.-----Tells you exactly where your boat is and where the rocks are.-----And more important where there ARE NO ROCKS.-----Looked at the chart and I would think GPS is a MUST have item.
  12. R

    Tell tale or bubbler what’s normal w/o a thermostat

    Years ago I had a fellow come in complaining that his 15 Johnson would not idle properly.----Had the fuel pump in pieces in a plastic tub.-----I looked at the pump and re-assembled it as there was nothing wrong.-----Found that his thermostat was stuck open and in 4 degree C (39 F ) his motor...
  13. R

    Evinrude 9.9 carb question

    Well-----The factory kits come with clear instructions to help folks who are learning this simple stuff.
  14. R

    Evinrude 9.9 carb question

    To me it appears that the needles are the same at the working end !!
  15. R

    Spark plugs

    Gave to agree ---airshot
  16. R

    150hp Johnson VRO removal

    Once a motor starts , the manual pump ( bubble ) is not hard.----And it does not need to be !
  17. R

    Bad rectifier or stator??

    Choke / primer valve is manually operated.----No automatic choke.----If motor takes long to warm up then , check thermostats.
  18. R

    Bad rectifier or stator??

    Guessing does get expensive.----These parts can be tested.----You should not be running the engine with battery disconnected.----Might as well test stator windings for battery charging and replace rectifier / regulator.----Does spark jump a gap of 3/8" pm all leads?----Be a good idea to post...
  19. R

    Fuel pump Gale 12S13B

    There are numerous fuel pumps that can be fitted to this motor.----In my opinion almost every shop would have some around in a bin.-----Any smaller ( up to 25 HP ) Johnson / Evinrude from about 1965 to 2005 uses the same style of pump.----I say it a lot, very easy to adapt something.
  20. R

    Help! 2000 Johnson 90hp V4 overheating on one side only...

    I would think there is a severe corrosion issue in the exhaust housing.----Where water flow splits to go to either side.----May have a look at some housings later today to see if that is possible.-----And a co-incidence it was noticed after shop worked on it.
Top