Search results

  1. Bondo

    cobra 3.0 hesitates

    Ayuh,..... I agree,.... more likely lean, than rich,.... Have you tried turning the idle air screws out just abit,..?? Is the acc. pump, working in time,..?? Hows the fuel filter lookin',..??
  2. Bondo

    Started, died and wont restart

    Ayuh,...... Even just sparkin' outa the tower to the tiny terminal, it usually carbon tracks, 'n ruins the coil,....
  3. Bondo

    Started, died and wont restart

    Ayuh,..... If you just remove it, it's highly likely to jump a spark from the tower, to it's (-) tiny terminal,.....
  4. Bondo

    Need direction

    Ayuh,..... Welcome Aboard,...... Do you mean like the 5.3l V8s,..?? The 350 is the good ole SBC motor, 'n works just fine, right up to it's last iteration,....
  5. Bondo

    Looking for tips and tricks for installing Bravo transom assembly

    Ayuh,...... I often use ole cut-out patterns, either still in the barge I rebuildin' the transom on, as well as ole cut-out patterns cut outta ole hulls,.... Use to have an ole Starcrift aluminum transom,... great pattern, light-weight,.... But some scrapper stole it for it's metal...
  6. Bondo

    bilge problem

    Ayuh,..... What it does, is kills the battery,.....
  7. Bondo

    Steering cable issue

    Ayuh,..... Sounds like it was put on, way to tight, 'n then corroded,..... Don't have an answer for ya, but, yes, the nut has to rotate free of the cable housing,...... When you put it back together, slather it with perfect seal(form-a-gasket #3), 'n just snug it tight,....
  8. Bondo

    bilge problem

    Ayuh,...... Welcome Aboard,.... I once bought a rule automatic pump like that,..... it sucked,..... I rewired it through a float switch insteada that automatic chip,....
  9. Bondo

    Steering cable issue

    Ayuh,.... But they're not,.... Have you tried penetrating oil, 'n tapping it with a hammer,..??
  10. Bondo

    Just acquired a boat, needs new prop

    Ayuh,..... Welcome Aboard,..... As QBhoy says, go run it, 'n see what it'll do for rpms, at Wot, to see what you need for prop pitch,....
  11. Bondo

    How much did a 2008 19' alumaweld stryker sport jet cost brand new in 2008?

    Ayuh,..... The rubber blocks rot out with time, replacement is the only fix,....
  12. Bondo

    Fuel capacity

    Ayuh,..... Welcome Aboard,..... The most common part number for those ole 470s is,...... NLA,.....
  13. Bondo

    Steering cable issue

    Ayuh,..... You can try it, but don't heat it to hot, 'n be careful you don't catch the boat on fire,..... Isn't there a set of wrench flats on the tube, for holdin' it, while you turn the nut,..??
  14. Bondo

    Lost gearage?

    Ayuh,...... Please read, 'n follow our posting rules, 'n guidelines,...... There's a link in my signature,...... ;) Btw,..... You want a Complete drive,...... All that ground up metal, migrated down into yer lower unit,..... It can't be run, without a full on rebuild,.....
  15. Bondo

    Need help with plugs selection

    Ayuh,..... So long as a spark plug, Sparks,...... What more would you want,..??
  16. Bondo

    Unknown Short Circuit

    Ayuh,..... The purple/ yellow wire feeds power from the starter's solenoid to the fuel pump,.. Only while the starter is engaged,..... aka: the start circuit,..... When you let off the key, that wire goes dead, 'n the fuel pump runs off the ignition circuit, which are the purple wires,.....
  17. Bondo

    Lost gearage?

    Ayuh,..... Donno the thread, nor the context,...... You can mount a Alpha 1 to a Gen.II bellhousing, but only after you swap all of the shift linkages to gen.I, 'n the oil fill port would have to be plugged, or you could swap in a Alpha 1 bellhousing(I think), but then you've got a gen.I, 'n...
  18. Bondo

    1996 SeaRay Sundeck 240 I/O

    Ayuh,...... Have one built at yer local canvas shop,....
  19. Bondo

    Started, died and wont restart

    Hold it to the block,...
  20. Bondo

    Started, died and wont restart

    Ayuh,...... Just pull the coil wire, 'n ground it,.....
Top