crab cap wire order http://www.2carpros.com/forum/automo...ireorder_1.jpg
firing order for GM is 1,8,4,3,6,5,7,2 but that's not how the cap is wired. Did not see this mentioned in the manual and if you used the firing order it would not run right.
Like the title says, my buddy`s big block was acting funny. low compression , slight moisture issue. pulled the head and found the gasket blown between 2 and 4.
#4 intake lifter depressed about a 1/4 inch more than the rest.So new lifters and a head check coming.
What we did find that is worry...
What is the name of the unit that does the controlling? dash has a panel with 9 functions , and it all goes to a main control box in the engine room.
Cant seem to find it. Not Smartcraft System or vessel view.
For those impossible to find deck drains use a thru hull fitting shaved down to fit. Most will simply screw into the OEM threaded fitting.
If you cut off the hose area. The Wellcraft 28 coastal uses these for deck drains and fish box drains. Chucked in a lathe to skin it and reduce the diameter...
taking forever to load , 2 minutes to get to new topic, over 2 minutes to get a post up so you can respond to it.
sometime it dosent accept your post, or takes forever to post it or comes back with "critical error"
Somebody pass this to the IT guy`s.
very, very slow to respond, very slow to access a post, almost forever to have your typed response get posted, very long to return to a screen and the advertisements seem to have a lot to do with the slow down.
Happening again, post says 3 and you post an answer and it still says 3 . You have to access your post to see a response not just look at the response numbers
Check this site out to equip your hyd pump with a remote power feed in case you get dead batteries
http://www.waytekwire.com/products/12/Anderson-Connectors/
How to install the missing grease fitting that prevents steeering arm water leak, updated with measurements
http://vid57.photobucket.com/albums/...ps9bfb7b84.mp4
yahama 150, need a bit of guidence
Motor is 150TXRM 6G4 UL 756892
Took on a job to replace the shift rod and I think i have all the bolts,nuts removed except for 2 long ones. the rearmost one on the port side and the middle one on the stbd side.The other 4 came out with moderate pressure...
