Search results

  1. kingsfisherman

    over fueling at idle

    It's very concerning when it drips from the TBI , the first time I noticed was when there was a puddle of fuel on the intake
  2. kingsfisherman

    over fueling at idle

    more pics of TBI after over fueling
  3. kingsfisherman

    over fueling at idle

    here is a pic of one time it frothed up, almost looked like frost
  4. kingsfisherman

    over fueling at idle

    Hello, I have had this problem for some time and done some parts chasing as well, at cold start up after a few seconds the engine loads up and black smoke comes out the exhaust. I hear a strong vacuum sound during this time and usually I add throttle to clear it up and get it smoothed out. After...
  5. kingsfisherman

    SX-M Trim

    there's a trim limiting module, I got one off of Ebay for my DP-sm. keeps the drive in the safe zone for trim
  6. kingsfisherman

    2005 Penta Sx-m replacement

    I would think as long as everything matches up with the transom shield and its the correct ratio should be good to go.
  7. kingsfisherman

    2005 Penta Sx-m replacement

    SX-m is a joint venture drive, should have an ID tag on it with the part number for the drive
  8. kingsfisherman

    4,3Gi different fuel pressure?

    Hey guys, great thread with a lot of information, I am rebuilding my Rochester TBI unit 17096259 for my 1998 5.7 GSi and I am looking for a rebuild kit that contains the correct pressure regulator diaphram. I'm also trying to understand this fuel system whether or not it operates on the higher...
  9. kingsfisherman

    TBI rebuild help needed

    Hello, I am rebuilding my Rochester TBI unit 17096259 for my 1998 5.7 GSi and I am looking for a rebuild kit that contains the correct pressure regulator diaphram. Does anyone know the part number for the diaphram? Can you help me find it? thank you, Tony F.
  10. kingsfisherman

    fuel tank pick up gasket material

    Thank you again Scott, I will check local auto parts store for some.
  11. kingsfisherman

    fuel tank pick up gasket material

    thank you Scott Thank you, Scott. would this be the same EPDM roofers use?
  12. kingsfisherman

    fuel tank pick up gasket material

    Hello all, I am replacing the fuel tank pick up flanges on my fuel tank. I want to reuse the existing ones until I get the new ones sent to me so I'm going to just replace the gaskets for now. I am looking for recommendations on what material to use. TIA
  13. kingsfisherman

    Sealing compound for DP-SM / SX lower assy

    hee's what I found in the service manual.
  14. kingsfisherman

    Volvo Penta 5.7 GSIPWTR Temp Sender

    the 5.7 GSi WT model is a TBI system with a knock module and MAP sensor, I'm not aware of a "air intake temperature sensor" on these models https://www.crowleymarine.com/johnson-evinrude/1122.cfm
  15. kingsfisherman

    Sealing compound for DP-SM / SX lower assy

    I have the VP Service manuals and will look to see what it says to use. I know where it says to use a sealing compound for the outdrive mounting bolts I use pipe thread sealant.
  16. kingsfisherman

    bushings for TBI shaft

    Hello, I am trying to find the bushing set for the shaft in a GM TB I on my '98 5.7 GSI.
  17. kingsfisherman

    Water in 4 cylinders

    yup did it once already last weekend and got enough oil to change it twice more. Hopefully it wiil be cleared up after 2 more changes.
  18. kingsfisherman

    Water in 4 cylinders

    apparently I did get lucky, I started it up and got it to run good, turns out it was flooded. No pun intended.
  19. kingsfisherman

    Water in 4 cylinders

    Thank you Dubs, I am going to do a compression test but not sure about being able to get the engine up to operating temp first before testing? Will it hurt to run it to get it up to temp?
  20. kingsfisherman

    Water in 4 cylinders

    Thank you, t, I pulled the plugs and cranked it over and blew the water out, then shot WD40 in each cylinder and cranked some more. Everything sound normal after the oringinal cranking which it made a pop then cranked normal. It starts like it starving for fuel then runs rough.
Top