Search results

  1. dingbat

    Lenco joystick/dual prop electric

    Electric actuators work but trolling motors do not. Solution Sequence: 1.1 Check system On/Off switch located on the main control box. Ensure that the switch is in the On position. 1.2. Check the foot control connector located on the wire harness attached to the main control box. Verify that...
  2. dingbat

    The Argo App, The Waze Type App for Water Navigation. Free

    Let us know how it works out for you Very leery of a app for "ocean navigation" given that cell coverage in coastal areas is typically "spotty" at best.
  3. dingbat

    Short circuit ? VP 3.0 GSP-A

    Should not be continuity between the battery positive and the block. Pull battery cable off and try again. If it goes away you have a ground leak. Electric motors are notorious for ground leaks. The bilge pump is the prime suspect
  4. dingbat

    Steering play in Helm Teleflex Tilt Rotary Hub

    How much play are you talking about? Even new, your looking at 10 degrees or so in slop
  5. dingbat

    Replacing my speedometer pickup what sealant to use

    Are you sure you’re not mixing “chemicals up? According to all the material comparability charts that I found, acetate has excellent compatibility with aluminum A goggle search for “Acetate etching aluminum” turns up nothing as well
  6. dingbat

    Surge Trailer brakes

    Not bleed completely or an adjustment issue
  7. dingbat

    Replacing my speedometer pickup what sealant to use

    Never heard of such a thing. Please elaborate…
  8. dingbat

    2007 Honda 225 loss of power

    I guess they could have a forging operation to change serial numbers so they could send you other peoples injectors for unknown reasons. How exactly do you test the flow and spray pattern of an injector by dumping a bottle of naphtha in the fuel tank? Do you pour a bag of o-ring and seals in...
  9. dingbat

    2007 Honda 225 loss of power

    Save that for carbureted motors. Ideally, Injectors need to be removed and cleaned every so often as PM
  10. dingbat

    Trying to find ignition key OMC #125

    eBay
  11. dingbat

    towing - engine in neutral?

    How much torque does a starter generate? Put the motor in gear, put a torque wrench on the prop nut, and try to turn it over in gear. Let us know how you make out…
  12. dingbat

    2007 Honda 225 loss of power

    Whole lot of rpm missing if the boat hit 6000 rpm when you got it. Could be a throttle position issue. injectors could need cleaned. How long since the motor had a good health check up?
  13. dingbat

    Steering play in Helm Teleflex Tilt Rotary Hub

    Make sure the nut holding the steering cable in the helm is tight. Had a Sea Star hydraulic steering kit in my shopping cart. Ran out to the boat to get a last minute measurement to order the hoses. By chance, found the cable nut had backed off a 1/4 turn. Put a wrench on it, problem gone...
  14. dingbat

    Add cleat to trailer?

    Unfortunately, that wouldn't work for me. Roller trailer with electric winch. 5/8" rode would not fit through bow eye with winch still attached. Use the "bow lifting ring" (center line cleat) rated for the weight of the boat
  15. dingbat

    Why I'm nervous boating at night...

    Coming back into the inlet from 20 miles south late one night. Nothing on radar......caught the "flick of a BIC" out the corner on my eye passing the outer buoy. Two people in a small skiff tied to the buoy. Using a lighter to signal passing boats as they went by. I immediately cut the...
  16. dingbat

    Vault Wheel Hubs

    You don't.... You can carry a spare hub or an entire hub/spindle assembly if you your torsion axle have removable spindles. A lot easier to change than rebuild on the side of the road.
  17. dingbat

    My Boat cut out when I hit a decent size wave today. Merc A1G1 3.0.

    The fact that it died and would restart would lead me to the kill or shift switch. Only thing I can think of the would instantly kill a motor yet come right back up w/o intervention
  18. dingbat

    Glass Fuse Amp?

    A fuse is a fuse…. Glass or ceramic doesn’t matter, well at least in this application. Forgetting to hook up a positive lead will not blow a fuse. That is, unless the circuit in question is being back feed from another circuit. In that case, all bets are off Either they didn't match up the...
  19. dingbat

    Needing a t top

    No mention of attachment to boat.... referring to assembly instructions showing the frames are screwed together with set screws and pole and socket connections. Mine is welded (OEM). 2" diameter, schedule 40 aluminum tubing. Have repaired (welded) a couple of small stress cracks in the primary...
  20. dingbat

    Vault Wheel Hubs

    You would have too.......they not "field" repairable. Any attempt to do would void the 5 year, upgrade to 10 year, warranty that comes with them
Top