Search results

  1. P

    Carb bolt torque

    The carb to the manifold. Sorry
  2. P

    Carb bolt torque

    mercruiser 2bbl carb. What is bolt torque
  3. P

    Fuel line

    Has anyone upgraded to trident barrier a1 . If so any input
  4. P

    Starved for fuel

    plugs,rotor,cap,oil and filter. Lower unit inpeller and oil. Nothing to timing. Put 10 gals in this morning.
  5. P

    Starved for fuel

    Mechanical. I just put that on to prime as no gas was flowing. Will remove when running again.
  6. P

    Starved for fuel

    I rebuikt the carb 3 years ago and it solved this same issue.. i had a clear inline filer so i could see low to no flow
  7. P

    Starved for fuel

    Did full tune up so thought a good idea. Gas in tank maybe at 4in above bottom maybe pickup tube is higher. Never let it go below a 1/4. Going to fill up today and see if that helps. Im thinking fuel pump is pretty tough so maybe the carb if it primes but stalls?
  8. P

    Starved for fuel

    It was in there for 5 months. Its a 3.0 mercruiser. I put a bulb on and squeezed didnt seem to prime
  9. P

    Starved for fuel

    i emptied the tank and put in 5 gal new fuel and sea foam. wont stay running. Was fine before . Does it need more fuel or primed ,carb rebuild or fuel pump.
  10. P

    What to paint the lower unit of outboard with?

    I have 2 coats zinc primer.3 coats mercury black.2 coats mercury clear coat. Can i put vs721 on lower unit to help with algae?
  11. P

    Primer amd paint

    I got all the growth off.And I have 2 Coats of primer hardening on here.My question is do I need to send this for adhesion or just paint with the mercury phantom paint 2x then clear coat 2x
  12. P

    Outdrive cannot clean

    2 days 1 hr each wet sand. I think it may not be pitted but calcified. Im sure i must prime and paint after this
  13. P

    Outdrive cannot clean

    I don't have a lot of peeling paint as you can see so do I prime over that and then paint it over the Existing paint
  14. P

    Outdrive cannot clean

    I checked the bonding wire it is frayed but still solid so ill replace.
  15. P

    Outdrive cannot clean

    Yes at the marina left on tricle charger
  16. P

    Outdrive cannot clean

    Pictures of outdrive
  17. P

    Outdrive cannot clean

    I'm thinking this is because my annodes didnt protect???. I've tried cleaning and also a little bit of sandpaper.But then I stopped pretty quickly. Any suggestions?On what to do with this before I put it back in the water. Do I paint it? Or just let it go until next year. I have replaced my...
  18. P

    Thermostat gaskets 3.0 merc

    Thank you. Senser in below thermostat.
  19. P

    Thermostat gaskets 3.0 merc

    I also cleaned out a cork gasket from underneath the thermostat.And replaced that with the cork gasket that came in the kit oring too tall with that in there for plastic retainer to be level.
  20. P

    Thermostat gaskets 3.0 merc

    The biggest 1 has 2 metal grommets in it.I was thinking about using the next one.That doesn't have grommets .What do you think
Top