Search results

  1. dingbat

    Electronic controls

    Looks like Electronic control are 150 HP and up
  2. dingbat

    Lenco trim tab switch

    Are you sure the contact module don’t just clip back on the switch?
  3. dingbat

    Electronic controls

    What year?
  4. dingbat

    1992 Evinrude 150 Oceanpro

    Runs cold...smokes like a chimney, oil runs out of exhaust ports, fouls plugs and carbons up the combustion chambers. Makes a real mess once water temps get down in the 50's Running in SW, make sure you get SS thermostats. Mine are 10 years old and still look like new. Rough idle compared to...
  5. dingbat

    replacing tires

    3 ton floor jack under (square) axle right behind the spring clamp.
  6. dingbat

    Winter Storage

    Not sure what fogging accomplishes on a 2 stroke given the internals are constantly covered in fuel and oil mixture? If you feel the necessity to fog for whatever reason, simply choke and crank the motor over a couple of rotations. The fuel evaporates over time leaving a thick oil coating on...
  7. dingbat

    Battery low alarm

    A fully charged 12 volt battery is 12.7 volts. A starting battery is technically dead at 12.0 volts. The current draw of a starter drops voltage between 1-2 volts depending on the starter. This puts you at 11.7 to 10.7 volts at start. If your battery drops below 10 volts your battery and or...
  8. dingbat

    Hummingbird no fish alarm

    Agree…I go as far as to run my sounders in manual mode. Make adjustments to range, gain and sensitivity as needed, manually. A real pain on units with menu driven controls. Much prefer units with push buttons and knobs
  9. dingbat

    What is this on the transom?

    Took me a minute to figure out what I was looking at in your screen shot. The presentation is much different than Garmin ClearVu. Image looks like a cross between down scan and side scan. Turns out the difference is in the transducers. Garmin uses a 3 crystal transducer with a dedicated to...
  10. dingbat

    Hummingbird no fish alarm

    You’re probably better off that it doesn’t… How does the unit know if the return is a fish or a stick? Not sure what you’re expecting… the sounder doesn’t find the fish.. that’s your job. They just confirm the presence of fish
  11. dingbat

    What is this on the transom?

    Don't worry about it......misinterpreted your post as being able to see "amazing details" at 650 ft. I have no problems seeing larger objects up to 75 ft. in calm water. The lack of "heave compensation" on the unit really puts a hurt on locating fish sized targets that those depths in open water.
  12. dingbat

    What is this on the transom?

    Would love to see some screen shots and know what unit/ transducer your using to get "amazing detail" in 650 ft. of water. Running a Garmin with a 500W GT51M transducer. Traditional CHIRP gets me to @ 1,200 ft, but I run out of juice with side scan in the 70-75 ft. range. ClearVu gets me in...
  13. dingbat

    What is this on the transom?

    Shoot thru installations work for depth. Not so good for fish finding. Introduces a frequency shift and a significant loose of sensitivity. Even with a “wet tank” installation, I was loosing almost 50% of my signal with a 600W RMS sounder Can’t do shoot thru because of the geometry and the...
  14. dingbat

    5.3 Direct Injection Volvo motor carbon cleaning. Often a problem and done on 5.3 GM vehicles - why not on boats?

    in https://engineerine.com/what-is-problem-with-gdi-engines/#GDI_Engines
  15. dingbat

    Slightly warm trailer hub

    Pretty common for bearings to "loosen up" after installation especially when putting new bearings and hubs into service the first time. I purposely leave the bearings tight during the initial installation knowing that they will loosen up over time. Put a round trip on them (120 miles) and...
  16. dingbat

    Fuel treatment question.....

    Sat out the season after ACDF surgery last fall. Have roughly 25 gallons of stabilized fuel from last July. Pulled the boat out to fire it up for a trip next week. Fuel actually looked and smelled pretty good. Plan is to add another 25 gallons of 93 Octane E10 and run it. Storing fuel in an...
  17. dingbat

    Trailer Axle Wear Sleeve Alternatives?

    A piece of 1.5” pvc fit mine almost perfectly. Here is a pretty ingenious hack. https://www.yesterdaystractors.com/cgi-bin/viewit.cgi?bd=farmall&th=767543 You’ll need #2 permatex (non-hardening) as a sealer
  18. dingbat

    Trailer Axle Wear Sleeve Alternatives?

    Read the small print on the spindle sleeves. Bought one when I went through this process a couple years back. The sleeve I purchased required a seal different from IE supply. Still sitting in the junk box in the garage. 99149 is the industry sleeve size Google…. Wear seal 99149 Here is one...
  19. dingbat

    Should I opt for oil delete? confused. seeking expert consult

    WD is good for cleaning but I would forgo the white lithium grease for something a little more water resistant. I've had very good results with Evinrude Triple-guard Grease and Yamaha Marine grease in this application Would also highly recommend a "cable nut" once you get everything cleaned...
  20. dingbat

    Multi function display

    It would work but looking at the docs its does way more than basic engine data. I would be concerned with the "ease of use" of the HMI interface. Not a fan of "push button" menu structures
Top