Search results

  1. M

    Deck carpet layout

    Then I am still confused , he states deck is 1.7m wide and material is 1.8 wide. In my mind 1.8 will cover 1.7 without any seams needed.
  2. M

    Deck carpet layout

    Not sure I understand what the " stitch " is means or "gunnel " for that matter. gunwale , which is the topside of the sides of your boat that you step on to get in the boat. Think you mean fastening along the sides . If your talking about fastening the carpet to the deck , mine was just done...
  3. M

    Bladders insert for fuel tank leak

    I am curious as to how you could insert a bladder thick enough to stop a leak and flimsy enough to stuff it through your 2" or so sending unit access hole ? Then you have the fill hole and air vent to deal with. After reading what I wrote , someone please send me a link to these " insertable...
  4. M

    Bayliner toilet 2651

    Same thing, didn't think I had to spell it out.
  5. M

    Engine bay part identify

    Seriously you give zero info , show a lousy picture and want us to guess where your hoses go. Get down on your hands and knees ( like we all did when we started out and I still do it to this day with wires and what not. )and follow the hose ,have someone else in the engine bay if need be and...
  6. M

    Engine bay part identify

    Follow the hose , not that hard
  7. M

    Bayliner toilet 2651

    No the shower drain should have a separate bilge pump located in small plastic container that catches the crud before it hits the bilge. No macerator pumps on boats that are on fresh / inland waters. If it had one ,in all likelyhood you would have a valve to open when using it and close it...
  8. M

    Transom Browning

    Pain to remove unless you buy the appropriate hull cleaner, which will probably have some sort of muratic acid in it . You can buy that from a hardware store and dilute it vs the "hull cleaner " Wipe or spray on wait a few minutes and wash off. THE big thing here is you should cover you trailer...
  9. M

    TaylorMade Vector Compact AC trouble

    Tamp Bay Marine Air .com would be the place I called or at least check out the website. Just has a issue , circuit board and controller had to be replaced . I would think that might be what you need , not the whole friggin thing . For what they cost and using it for a couple months at most if...
  10. M

    My boat won't get up on plane with 2 people on board.

    Tabs will help , but not solve your issue long term. I will say it again, your underpowered by a lot , you need at least a 35 hp and a 40 would be my choice , if you want a nice running rig. You are going to work that motor to death , plain and simple.
  11. M

    My boat won't get up on plane with 2 people on board.

    You are underpowered for the load your carrying , period. Going down in pitch will help you get out of the hole , but you are going to lose top end speed when you are out solo. Next up, do you have a tach ? It's a guessing game without it AND if you go down in pitch you have to be aware that...
  12. M

    Engine dies won't restart

    Do you have points or is it a Mercruiser with its own setup ? Has it been converted to a Petronix ignition system ? You could have a wire connection that is starting to go bad/corrosion and works intermittingly . Could be a distributor module going bad. Inboards do not have a momentary kill...
  13. M

    Identification help

    IMHO the boat looks better without the shield . Makes it easier doing any line handling on the fore deck. All hardware was outsourced and the boat itself , while old and having nice lines is one of 10s of thousands old aluminum hulls still plying the waters. Nothing special about it unless you...
  14. M

    Boat won’t plane out

    Coming off a pontoon boat my guess is your prop is under pitched or for some odd reason over pitched , depends on what your getting for max rpms right now. Next up would be your way underpowered depending on what your max HP label says. What motor was on it when you bought her ? You could have a...
  15. M

    Spray or roller for Wellwood carpet adhesive

    Not knowing what your putting the carpet on or what your main use of the boat is I wonder if you wouldn't be served better by using snaps. Just got through using Marine mat for one of my boats. Reasoning is , gluing to fiberglass will make it a mess when the carpet gives out and has to be...
  16. M

    1979 Penn Yan 26 foot

    Uhh , you hit the switch and see what goes on , you should/may have , wipers , blower , bilge pump , raw/fresh water pump , lights [ cockpit, spreader, underwater , running and anchor ] and a few others depending on who has tinkered with the switches. Not rocket science.
  17. M

    1979 Penn Yan 26 foot

    They sell label makers for under 30.00 I think. They work great, you can change the size of the letters and they adhere decently.
  18. M

    Thoughts on a 2005 Doral Thundercraft 240 Magnum?

    I think , not 100% sure , that you need a functioning head in order to have alcohol on board . No big deal "de-winterizing " it. Maybe a couple hoses get put back on along with hooking up a battery and that's it. Boat should be ready for showing at this time of the year to begin with , not your...
  19. M

    Problems with accessorys

    Your going to have to trace your wires from the items your trying to power up. Most boats will sound a alarm when starting them up. One of my boats keeps sounding after it starts , have to manually hit the alarm button that is on one of the gauge clusters to turn it off. The other one auto shuts...
  20. M

    Bilge pump upgrade. Bigger hose and wiring needed?

    Nothing wrong with getting the biggest one that matches up to your hose ! Your 1st post did not mention it was broke , just that you wanted to replace it. Lead me to think you were set on upgrading because of maybe taking on too much water for whatever reason. And to me at that point , your...
Top