Search results

  1. flyingscott

    2003 Mercury 25 HP won’t crank

    Does the flywheel turn by hand? Does it pull over easily? What is your compression?
  2. flyingscott

    flywheel removal

    Not the same.
  3. flyingscott

    15hp johnson problems starting after winter

    Did you keep pulling until the needle stopped? Minimum 5 pulls
  4. flyingscott

    15hp johnson problems starting after winter

    Make sure the carb is clean. Is the cam roller in good shape?
  5. flyingscott

    Lower crank shaft seal likely to sustain damage in pulling drive shaft?

    Take those 4 bolts off and pry that plate off carefully. I believe that only holds the seal. Once that is off you can see the splines so a little penetrating oil will go a long way. If I am wrong somebody will be along shortly to point that out.
  6. flyingscott

    leaking Johnson carburetor

    Sounds more like your float level is not correct.
  7. flyingscott

    15hp johnson problems starting after winter

    what yr is your motor? model #?
  8. flyingscott

    1986 Johnson 60 horse power - setting up idle?

    Have you done a link and sync? Make sure all the carb butterflies are closed. You do not care about idle timing at all.
  9. flyingscott

    1986 Johnson 60 horse power - setting up idle?

    Is the throttle cable pulling the linkage tight to the stop.
  10. flyingscott

    2008 Mercury 20 hp stalls after trolling

    2 strk or 4 strk carb or fuel injected?
  11. flyingscott

    Oil ratio 4 hp Evinrude

    50-1 fuel ratio
  12. flyingscott

    Decarboning a Crankcase.-

    Spray fogging oil on it and let it sit overnite.
  13. flyingscott

    Evinrude 15hp hard start.

    Are you turning the throttle as far towards fast as it will go?
  14. flyingscott

    20 hp Mariner No spark

    Never seen one of those go bad. Have you checked the kill switches? If it is a tiller pay attention to the one in the handle. Have you done a DVA test? Any tests beside continuity?
  15. flyingscott

    grommet sleeve

    The 90 deg crossflow is an entirely different motor than the 60 degree looper.
  16. flyingscott

    20hp mariner after service, speek still 13 to 14km/h

    How about a serial #
  17. flyingscott

    89 Mercury 25hp xd not getting gas

    if you bought a repair kit for the complete carb it will have gaskets for different models. Did you use the correct gaskets? What happens if you pump the primer ball? If it runs on the primer the problem is in the carb. The primer bypasses the carb altogether. The fuel pump gets its pulse...
  18. flyingscott

    Is a 1977 9.9 carb compatible to an 86 9.9?

    Yes
  19. flyingscott

    Fuel connector compatibility issues.

    Go to the parts fiche and it will give you the # you need
  20. flyingscott

    9.9/15 Front-to-back Armature Plate Movement

    That stator has nothing to do with the upper bearing it does not even touch it. Unless the flywheel itself is moving up/down or side to side your bearing is fine. Your problem is you have a 1974 9.9/15. Those stators were crappy from the get go, there were update kits that replaced most of the...
View older results
Top