Search results

  1. jimmbo

    1150 Link & Sync Question

    As mentioned it doesn't matter which gear it is in, as long as neither the Control Lever or the Shift Shaft on the gearcase is moved while apart
  2. jimmbo

    1974 Mercury 115hp I6 2 stroke lower unit put back in help

    On yours the Distributor will block the Top Carb but the bottom two will be visible. The throttle shafts run vertically through the carbs and you can observe their rotation. Ignore the Arrows
  3. jimmbo

    '83 johnson, fuel not reaching cylinder

    I don't know what you consider Scored... Valves? Valve Cover?
  4. jimmbo

    Mercury 35 hp outboard timing

    When the Engine died on the Water, It just quit, or did it slow down and then quit?
  5. jimmbo

    Winner/Johnson basket case

    WOT: Wide Open Throttle
  6. jimmbo

    Mercury 35 hp outboard timing

    What's the Serial Number of the Engine?
  7. jimmbo

    Mercury 35 hp outboard timing

    Welcome to iboats. The 3 degrees is not an Idle Timing Spec. It is likely the Spec for the Primary Pickup, which when the Carb is just about to move from from being fully closed. Unlike older cars/truck engines, the timing is what adjusts the Idle Speed, as the Carbs are always fully closed at...
  8. jimmbo

    '83 johnson, fuel not reaching cylinder

    Ease up with the starting Fluid, that stuff is very good at stripping the Oil off the Internals that require it. You say it has spark. Have you tried spraying a bit of Premix into the carbs to see if it fires? The Compression Numbers are low, try another gauge. 1983. I will assume you are...
  9. jimmbo

    1993 - 2001 9.9 / 15 Maximum Spark Advance

    One less thing to be misadjusted
  10. jimmbo

    Thermostat on 235 Evinrude

    Pressure Relief Valve. Allows more cooling water to flow at higher rpms, and less at lower ones. Thermostat might be a little too small to permit enough flow to meet cooling requirements when engine is warm and running fast
  11. jimmbo

    1968 Evinrude 9.5 Speedtwin

    Welcome to iboats Have you checked for Spark, it needs to be able to jump a 5/16" gap
  12. jimmbo

    Winner/Johnson basket case

    Here are a couple of pages from the 1967 Johnson Brochure, and a Prop Chart for that engine. Back in the Day, there were only 5 Props for that engine, and these day they are getting harder to find, though they do appear on ebay from time to time. Based on the Model # you gave, it is a...
  13. jimmbo

    1974 Mercury 115hp I6 2 stroke lower unit put back in help

    There is No 'Easing' it into gear. It is either In or Out of Gear, so the quicker the Shift, the Longer the Clutch Dog and Gears last.
  14. jimmbo

    Merc Outboard - 2 Year Old Engine Failure, 5 Year Extended Warranty Denied

    Too Bad you didn't have the Merc Dealer do the winterizing. Bent Connecting Rods can occur when a Liquid is ingested while the engine is running at speeds higher than Idle. I guess if someone poured a pint of Fogging Oil down a Carb in less than a couple seconds and the engine was running about...
  15. jimmbo

    74 slickcraft 5.0

    Starter Solenoid sticking, Short in Key Switch, are the most likely Culprits
  16. jimmbo

    Best propeller pitch for Frankenstein build.

    Could be a Restriction somewhere in the Fuel System, including Tank Venting, Fuel Pickup in the tank, even a weak fuel pump. Have you tested the Pump for Flow and Pressure? Is there a Filter at the Carb? Is it a 2bbl or a 4bbl?
  17. jimmbo

    1974 Mercury 115hp I6 2 stroke lower unit put back in help

    Now you are saying it cranks and starts the Engine when you shift into Forward or Reverse?
  18. jimmbo

    New boat owner!

    A Boat is like a Hole in the Water, that you pour Money into
  19. jimmbo

    Best propeller pitch for Frankenstein build.

    Old Fuel, can leave its Mark on a Fuel System for a long time, in the form of Gum and Varnish, plugging/restricting Passages and Air Bleeds
Top