Search results

  1. S

    1994 Johnson 115hp, V-4 engine questions

    Straight in the back between the heads, big bubble cover.
  2. S

    '97 Johnson 130 HP - Stalls when under load (only after running OK under load 1st)

    They prefer you start your own thread and post a link to this naming it as your issue. Very unlikely you will hear from the original post from 2011. That said, is your engine a vro?
  3. S

    1994 Johnson 115hp, V-4 engine questions

    Just looked up your engine, part 13 says it's mounted on the exhaust cover. Look for a small 90 there.
  4. S

    1994 Johnson 115hp, V-4 engine questions

    By the way, motor doesn't come with the pressure sending port for the head, it comes in a kit with the pressure gauge. Your right, someone probably removed it.
  5. S

    1994 Johnson 115hp, V-4 engine questions

    I was wondering if it has a system tach that will show visual alarms to. Tell tale is the pee tube, that tells you the water pump is working but it doesn't tell you if your overheating just like the water pressure gauge either. If your t-stat is hung up or you have internal plugs your pressure...
  6. S

    1994 Johnson 115hp, V-4 engine questions

    Yes, my bad....it was in the tread title. Thanks
  7. S

    1994 Johnson 115hp, V-4 engine questions

    Water temp and fuel/oil level/pressure are audible alarms produced at the control box assuming they are working correctly. Better than visual because you should be looking at the water when running. What is the HP and does it have a tach? If so post a picture. Water pressure gauge is a fitting...
  8. S

    Johnson 70 HP alternative for part for Lever to Link Guide - 0336456

    Figures
  9. S

    1997 115, bogging down

  10. S

    98 Johnson leaking hydraulic fluid.

    All I could find online. Might be broken off or missing. Look for a hole.
  11. S

    98 Johnson leaking hydraulic fluid.

    More towards the top. Edit, actually I think it's down low.
  12. S

    98 Johnson leaking hydraulic fluid.

    Part #2 .....3 required per assembly.
  13. S

    98 Johnson leaking hydraulic fluid.

    I've never seen a grease fitting in there. 2 on the tilt brackets and one on the swivel tube.
  14. S

    1979 Johnson 9.9 Water Exiting Exhaust Relief Holes

    I have that clear it more than once. If that doesn't do it you better check out your impeller or the gaskets you installed.
  15. S

    1979 Johnson 9.9 Water Exiting Exhaust Relief Holes

    Did you remove and blow out the pee tube? Also, remove the fitting on the block that the pee tube sticks in, start the motor and see if it clears out. It likes to log jam there.
  16. S

    Evinrude 25202r WOT adjustment

    There are better ones than this but these are inexpensive and get the job done.
  17. S

    1979 Johnson 9.9 Water Exiting Exhaust Relief Holes

    Yes it's normal. Your teltale is weak. Pull the rubber hose off and blow it out.
  18. S

    surging issue

    Here is something it could be. I had that exact same thing happen many years ago. My tank ended up being the issue and this is how we found out. Same symptoms. We finally hooked it up to a portable tank and it ran fine. So I pulled the intake pipe from the main tank and notice it had a screen...
  19. S

    2002 Johnson 15hp 4 stroke questions

    On the pee stream tough to say....purchase a ir gun and test the head temp. Cheap buy at Harbor Freight. As for the steering swivel tension, there should be a spring over screw somewhere below the power head near the top of the swivel bracket. Part number 27
  20. S

    Johnson 70 HP alternative for part for Lever to Link Guide - 0336456

    Not sure if this is real or not....other wise maybe someone with a parts motor. https://www.huntsmarine.com.au/products/guide-5
Top