Search results

  1. N

    So i decided to pull the powerhead off....

    As I mentioned in your other post about this issue you have to measure the output voltage from the stator windings, the triggers and the CDI boxes with a DVA meter. You can use a regular VOM but with a DVA meter or a DVA adapter connected to the VOM you are able to read the peak DC voltage...
  2. N

    60s era 9.9 Chrysler autoelectric outboard model 923

    PM me and I will send you a wiring diagram for this motor or the similar 9,2, 20Hp with autoelectric (dyna starter) starter. I will check in my books and workshop collection which diagram I have. I worked on a 1968 20Hp last autumn and from what I remember there was just a couple of screws and...
  3. N

    60s era 9.9 Chrysler autoelectric outboard model 923

    I think you have blown a fuse or tripped a auto fuse. Have not checked with the wire diagram yet but will look at it later. To remove the dyna start winding and to access the flywheel you have to have a special tool. The winding is fitted to a taper and you need the special tool to get it loose...
  4. N

    1989 Force Gamefisher shift linkage adjustment

    I suppose the LU is the same style as the older Chrysler 9,9-15Hp. I think the lower shift shaft is not adjusted properly if the clutch dog edges and the edge at the gear looks good. The edges should be perpendicular and not rounded. In the workshop manual there is a distance from the split edge...
  5. N

    puzzled 88 85 hp has strong spark on number 2 cylinder and super weak spark on 1,3

    As I mentioned in the other post of this issue you have to either check the output voltage for the triggers, the stator and the CDI boxes with a DVA meter and/or check how far the ignition coils can jump the spark, as raceone suggest. Your bulb spark tester are not a good tool for...
  6. N

    puzzled 88 85 hp has strong spark on number 2 cylinder and super weak spark on 1,3

    Have you measure the stator output to the CDI boxes and the output voltage from the CDI boxes to the coils with a DVA meter?
  7. N

    73 chrysler magnapower motorola CD-unite resistance levels

    If it is the Motorola Magna Power I system with the coil with grooves, part number 345375-1. Prime side resistance 0,2-0,24 Ohm Secondary side resistance 500-570 Ohm.
  8. N

    Chrysler Sea King 9.2hp Water Pump info

    Yes it should be -2 instead of -1. My mistake.
  9. N

    1975 25HP thermostat

    I have two 25Hp right now and have had at least six or seven of them and none of them hav had a thermostat. As jerry says, they made a place for one but did not use one.
  10. N

    Chrysler Sea King 9.2hp Water Pump info

    Maybe that one will fit, but the F429065-1 is for 9,2Hp if you check out Mastertech marine site. To be really sure contact Franz Marine, he will give you the right part number.
  11. N

    Need Points information for Sea King 9.2hp

    I do not have the parts list for this engine but I think the points are the same as for the later small Chrysler engines. It should be F12153-1. When I look at the pic and as you says you have spark but it would not fire maybe back fire I think you flywheel key is shared. The key should set the...
  12. N

    1966 Chrysler 50hp won't steer, missing fuel pump.

    As I said before your engine had the old style fuel pump from factory. The old style is mounted beside the block with a bracket. It is a two stage pump and it is driven from the crank case pulses (vaccum/overpressure) by two hoses. The newer style pump is bolted to the block at a intake port...
  13. N

    1966 Chrysler 50hp won't steer, missing fuel pump.

    Check out Ebay. There are 5-6 old style and 2-3 newer style fuel pumps out there. Search Chrysler outboard fuel pump.
  14. N

    Chrysler 1981 55HP Possible CD problem

    Joe I can not say if the magnetic field is strong enough but as the trigger magnet is smaller and it suppose to generate a low voltage to the CDI box to dump the capacitor voltage, it would not be so strong. I would suggest you to take a closer look at the trigger ring. As the triggers purpose...
  15. N

    1966 Chrysler 50hp won't steer, missing fuel pump.

    About the steering problem try to penetrate more with penetrating oil and warm/heat it up with a propane torch. Try to lobe with new grease through the grease fitting. Do not heat to much, there are plastic bushings for the swivel bracket bearing. It is a PIA to work with stiff steering but be...
  16. N

    Chrysler 1981 55HP Possible CD problem

    0,5 VDC or higher from triggers. 180 VDC or more from stator to CDI box (blue-yellow) connected. Orange and red are output to each coil. No spec. of output from CDI box to coil.
  17. N

    need starter for chrysler 70hp model 707hf availability

    As raceone says check the flywheel key. Really easy to check, pull the plugs and find the TDC at top plug with a screwdriver. At TDC the 0 dgr mark at flywheel should point and line up with the 0 dgr mark at timing tab. Also check the curved line at the distributor pull, It should line up with...
  18. N

    need starter for chrysler 70hp model 707hf availability

    Do not buy a cheap starter from China. Rebuild you OEM starter, the cheap Chinese or Taiwan starter is junk.
  19. N

    Chrysler 1981 55HP Possible CD problem

    Pull the flywheel off if you haven´t yet and check how it looks like. The magnet is a thin strip that is glued to the flywheel outer rim and it serves the stator windings charging the CDI box and battery. It is not uncommon the magnets get loose but then you loose spark. The trigger pick up...
  20. N

    Chrysler 1981 55HP Possible CD problem

    Well, I have no more information to add now. I think you have to change parts by now as it sparks and suddenly change the firing order. There are used CDI boxes at Ebay, but better to buy a new OEM or an aftermarket by CDI Electronics. CDI Electronics part number 116-5301, but really expensive...
Top