Search results

  1. alldodge

    Engine overheats after water heater failure

    Clear hose on pump line at thermostat housing Remove serpentine belt, remove the large hose on circulating pump and stick a thin screw drive up it., than see if you can hold the vanes while turning the pulley
  2. alldodge

    1973 mercruiser mc-1

    Is it no control or just a lot more play? Like at slow speed there is just a little play in the wheel and it gets worst with more speed?
  3. alldodge

    Mercruiser 4.3 TKS - No Ignition Power

    Welcome Looks like you found the problem, looks like a bad/broken connection on pin A. The 20amp fuse on the motor is the TKS fuse and has no bearing on your current issue. It's there to protect the helm wiring if something shorts out This is a block diagram of the TKS system
  4. alldodge

    Main Jet size for carb 7043183?

    Agree
  5. alldodge

    LOWER END OIL CHANGE

    Don't have one that old. Checked Mercruiser Alpha and Bravo and they are 40 in-lb. The Verado OB is 100 in-lb This manual list 55 in-lb MODELS 135-150-175-200-225 1992 and Newer – 135-150-150- XR6-150 Magnum III-150 EFI-175-175 EFI-200-200 EFI-150-200-225 Pro Max-150-200-225 Super Magnum I...
  6. alldodge

    Starter Issues 1998 4.3 mercruiser

    I don't think it's the starter, it's something else Did you rotate the motor enough by hand to look at all the teeth on the ring gear? Put a voltmeter on the starter post and crank the motor, how low does the voltage go?
  7. alldodge

    1986 Ski Nautique 2001 resto project

    Look forward to seeing the progress, and right ow is a bad time at iBoats because pics cannot be posted. We all hope that gets fixed soon
  8. alldodge

    Lower unit oil leak through weep hole after impeller replacement

    Might be other than the quad ring hole. Is shift shaft seal good, pump housing leaking?
  9. alldodge

    On throttle up the engine dies

    Might be fuel might be spark but need to do some testing Being a 1995 you might have EST ignition but might have TBV, motor serial numbers help us figure out what you have
  10. alldodge

    Console Wiring 1996 Sea Swirl Bowrider 201 Limited Edition

    This is typical helm wiring
  11. alldodge

    Engine overheats after water heater failure

    If your sure the gauge is close enough to be correct, than there is a blockage somewhere and the water heater was just coincidence
  12. alldodge

    Port motor out!

    Do what Scott mentioned. Can get a loaner tool from auto parts place. Should be 50 to 60 psi
  13. alldodge

    Main Jet size for carb 7043183?

    I'm sure there is in paper somewhere. Could ask a place like Mike's Carbs and he may have the info
  14. alldodge

    Main Jet size for carb 7043183?

    It's a Rochester carb jet number 1397-3827 but don't know the size https://www.perfprotech.com/mercury-marine-parts-catalog/search?serial=4506302#/diagrams/model/24554328245614/document/24554340780108
  15. alldodge

    2005 4.3 liter Mercruiser ignition trouble

    Pull the connector off and look at the pins, many times the pins become corroded This is where it's good to know actually which 4.3 your have. Being a 2005 and you saying it's a carb than most likely has a TKS
  16. alldodge

    What is this indicator? (2000 Bayliner)

    Don't know for sure but my Rinker had a switch added by the dealer. The issue is the digital depth gauge would get messed up, and to fix you would turn it off then back on It looks like same thing
  17. alldodge

    2005 4.3 liter Mercruiser ignition trouble

  18. alldodge

    99 Volvo 5.0GL

    Walmart Walmart will guarantee part Marine for less
  19. alldodge

    A few questions on a new to me 2020 Mustang GT

    Don't know about 20's but page 192 of the owners manual list 34psi for 235/45R18 = 212.9cm 37psi for 235/40R19 = 210.6cm A 235/35R20 = 211.1cm The circumference of each tire
  20. alldodge

    A few questions on a new to me 2020 Mustang GT

    Find the owners manual on line and see what it says about tires
Top