Search results

  1. R

    Surging Mercury (with audio)

    It sounds awful------Step #1 is a compression test.----Post the actual values here.----And does spark jump a gap of at least 3/8" on each lead ?
  2. R

    Need Help Identifying an OMC Lower Unit

    I have to agree with it being a Yamaha unit.----Looks to be 30 hp.----But could be 40 / 50 as well.
  3. R

    1995 90 HP Evinrude E90TLEO crossflow

    Keep those compression values for future reference.----Test once a season.-----I used to rebuild these motors on a regular bases.-----Simple / easy to maintain.-----Do not require $120+ / hr dealer support.
  4. R

    Why o' why?

    Have you drained the oil from the crankcase?---How much was in there ?-----Any water ?-----It is possible that the previous owner had no idea about motors.----Not uncommon today.----May have seen or heard that oil tank ( 2 stroke ) needs filled to the top.-----Did the same on this 4 stroke...
  5. R

    Boat won't turn right at speed

    Model # of the motor?----Is this a G2 model.
  6. R

    1995 90 HP Evinrude E90TLEO crossflow

    I think these VRO pumps are simple but way over priced.-----Simple to pull apart and inspect.-----Common fault is the flapper valve on the fuel piston,-------Simple to fix.----Do a compression test on the on this motor for future reference.-----There is a history of broken piston rings with...
  7. R

    Why o' why?

    If oil level is way up on a 4 stroke there are serious issues.
  8. R

    2003 yamaha 50 4-stroke runs rough

    Do you leave fuel in the carburetors when motor is out or service / boat on the trailer ?
  9. R

    Old motors DEMAND to be retired when they are 65 years old..

    I have a couple of those 1954 / 55 green CD models,-----No needle bearings on the rod journals like the 61 and newer ones.----Installed a new crankshaft in one of them in 1984 and is in storage since then.----Too many projects on the go.----Just great motors for fishing / trolling.------Picked...
  10. R

    Old motors DEMAND to be retired when they are 65 years old..

    Just picked up a 1962 and a 1964 model 5.5 HP Johnson.------Both are very low hour motors.----Will run like new again with a bit of work.-----These are just wonderful motors with little or no plastic on them.-----But if you have to run to a shop for repairs you will be shocked with their...
  11. R

    What would make a flywheel hard to spin? Starter won't spin it.

    Reed valves do not seize
  12. R

    Evinrude 55 1978 gearcase

    Find a good used empty gearcase.----Swap everything over.
  13. R

    2003 yamaha 50 4-stroke runs rough

    I have a couple of these fresh water motors.----One was declared scrap due to corrosion.-----Also given a 90 HP , declared scrap due to corrosion in water jackets !
  14. R

    2003 yamaha 50 4-stroke runs rough

    There were severe corrosion issues with motors of that era.-----Start with a compression test.----It sounds like a broken record on my part.-----Compression test is quick / easy / cost no $$$ and you learn a lot about health of the motor.
  15. R

    I have a 2000 90 hp Johnson model#J90PLSSE Fuel problem

    Does spark jump a gap of 3/8" or more on each lead ??----Post the actual compression test values.-----Water pump impeller replaced ?-----Possibly going into S.L.O.W. mode.----If your assistant operates the manual fuel pump , what happen ?----Why did you replace the VRO pump ?----Now mixing at...
  16. R

    Low compression - 1986 Mercury classic 50

    Remove bypass cover for #1 and have look at the piston and rings.----Post some pictures of what you see.
  17. R

    Low compression - 1986 Mercury classic 50

    Remove bypass cover for top cylinder.-----Inspect pistons and rings.---Easy to do and you learn lots.
  18. R

    Help!!

    Look for another model # somewhere.-------Perhaps inside on the lower cowling.
  19. R

    1985 9.9 evinrude misfire

    Checked fuel pump diaphragm? -----Cheap and easy to replace diaphragm if it is ruptured.
  20. R

    Most common problems with 4 cyl / 3cyl chrysler outboards

    I have trolled for hours and hours with a 63 Johnson 10 HP at 24:1 mix.----Rebuilt it myself.----Plugs do not foul.-----Find the real issue with your motors I say.
Top