Search results

  1. dingbat

    Need help with converting MSD toilet to just portable, carry off and dump.

    After looking at the kit you posted, the larger of the two certainly is not 1-1/2 NPT threaded cap as evidenced by the two piece design. Looks like a collar off a 1-1/2" trap adapter with a plastic thread protector as the cap The smaller one still looks to be a NPT cap, but the larger one...
  2. dingbat

    Rev 4 to something else

    Interesting…stainless on stainless is infamous for gulling. Goes against all engineering norms. Wait and see how that works out for them in the long run. Solid hubs shouldn’t be a problem if you have a good prop shop. Sent my 4 blade (Evinrude Offshore Renegade) out for balancing and polishing...
  3. dingbat

    Engine Overspeed?

    No, it’s not ok for any length of time. Limiting top end rpm to within rated rpm range is done by prop selection. You need to learn not to push the throttle to hard or increase the pitch of your prop
  4. dingbat

    Rev 4 to something else

    Stainless?? You mean SSR series? Just a different sleeve material/configuration. Assuming they use rubber instead of delrin (hard plastic) sleeves which are used on the regular Flo-torque. Had to go with a Rubex, RBX hub to get rid of the prop rattle on my Enertia
  5. dingbat

    my 1989 30hp yamaha is overheating, alarm goes off, motor is pissing strong, i check my thermostat \, it is missing, Could this cause to run hot?

    A “strong” pisser is a meaningless measure of flow through the motor. Yes, not having a thermostat will cause an overheat Heat transfer is a delicate balance between flow and surface area. Throw either out of balance and you have problems
  6. dingbat

    Johnson 1988 vro 225 hp fixing up a Frankenstein

    The orientation of the crank to flywheel is determined by the key way. Rotating the crank to locate a piston in a particular location isn’t going to change that
  7. dingbat

    2005 osprey new 380-c-b with dp nema2000 info

    I see no reason for it not to work as long as you didn't order a SeaTalk version
  8. dingbat

    Need help with converting MSD toilet to just portable, carry off and dump.

    Your too kind....any "emergencies" on my boat involves a 5 gallon bucket Looking at the parts manual for said unit, the unit has Discharge: PVC fitting connects to 1.5-in. (38 mm) ID discharge plumbing. Vent: 5/8-in. (16 mm) ID hose fitting Discharge - 1-1/2" Schedule 40 PVC Cap or Plug...
  9. dingbat

    2005 osprey new 380-c-b with dp nema2000 info

    What is a “yacht device” and an “ecv”? Are the device(s) NMEA 2000 compliant?
  10. dingbat

    Male and female rubber boots, tool and steel pins that wires get crimped in.

    Proper terminology would help….. Your looking for a (amphenol) ) connector (boot) with pins (little steel leads) and pin insertion tool (tool to push steel pins through boot) Connector part number can be found on your motor’s parts list
  11. dingbat

    i command gauges

    Hopefully you disconnected battery power before disconnecting everything else. ECM don't like to be connected or disconnected while "hot"
  12. dingbat

    Male and female rubber boots, tool and steel pins that wires get crimped in.

    https://obparts.com/spark-plug-ignition-wires/
  13. dingbat

    Need help with converting MSD toilet to just portable, carry off and dump.

    Kids only need to go to the bathroom after you leave the dock ;) Cleaning out a portable head a couple of times in the middle of summer will have you wishing you left well enough alone....lol After putting the "if you use it, you clean it rule" into effect, its strange how the kids no longer...
  14. dingbat

    Vinyl curtain shrinking.

    The materials expand and contract with temperature. My enclosure side covers are roughly 36 x 48 inches. Doing the math, they grow/shrink roughly 0.20" between 40°F and 100°F. Ideally one would fit the covers at 70°F to split the difference.
  15. dingbat

    Vinyl curtain shrinking.

    Not out of time but from the cold. My last boat had a bimini. Used to store the curtains in the truck for the ride down to launch. The warmth helped tremendously to snap and zip at launch.
  16. dingbat

    2007 Century 2600 WA Owners Manual

    Did you try their website or called them?
  17. dingbat

    Sea/Lake Food

    My favorite……..Atlantic Striped Bass
  18. dingbat

    Transom straps

    Thanks….had a powered winch on my roller trailer. Switched over to a drive on setup this Spring. Winch only used to pull the boat the last could of inches
  19. dingbat

    Tandem axle trailer weight?

    The #6k aluminum bunk trailer under my 226 Grady is #1430. The steel roller trailer it replaced was ~#200 heavier
  20. dingbat

    Penn or Cannon?

    Got me on the switches…. The only electric feature I use is “short stop”. An auto retrieve function that stops the ball at the surface since rough seas, gelcoat and #20 balls don’t play well together
View older results
Top