Search results

  1. Scott Danforth

    76 OMC 175 starting

    as mentioned above..... NO. its the opposite. the points are what open and close to energize the coil primary side, then allow the magnetic field to collapse allowing the secondary side to fire. without servicing the points, is expecting a toaster to work when its not plugged in. with...
  2. Scott Danforth

    76 OMC 175 starting

    Did you service the points?
  3. Scott Danforth

    1984 CVX20 Ski machine service manual

    The only legal place to get a new factory manual. https://outboardbooks.com/
  4. Scott Danforth

    Evinrude Sportwin 9.5hp Pinion Gear

    Any johnnyrude dealer can sell you parts
  5. Scott Danforth

    2008 bayliner 192 discovery

    5100 RPM. Rev limited to 5150 Most likely your tach is simply on the wrong setting
  6. Scott Danforth

    New Rescue Boat???

    Are the shallows rocky where you need the jet? Is there skid plates on the bottom like most shallow water jet boats? Some tunnel cats will run in 2" of water as well as a fair amount of chop. I remember there is a tunnel cats RIB that runs a jet that was designed for rescue. Can't remember...
  7. Scott Danforth

    2008 bayliner 192 discovery

    Your tach is off. The motor would grenade at 5700 RPM
  8. Scott Danforth

    Has anyone replaced the windshield on their boat?

    Check with Taylor Made However on curved windows. Be prepared when you get the quote. A new window may cost what you paid for the boat
  9. Scott Danforth

    2008 bayliner 192 discovery

    You pick the prop by which one gets the motor to the proper WOT RPM. NOT by the planing RPM
  10. Scott Danforth

    1999 Volvo penta 5.7 GSI stuttering/cutting out - temp gage

    For $13 you can get new distributor bushings from NAPA
  11. Scott Danforth

    Electric boat maker shutters plant in WV

    X shore is in Sarasota.... The boat has come in under tow almost every outing. Another brand used a Tesla battery. They had a leak into the bilge and the battery caught on fire The technology isn't there yet
  12. Scott Danforth

    Need to vent....

    Since you are drinking Natty...... Going to assume it's a head injury
  13. Scott Danforth

    Four Winns H190 Trailer bunks

    Because the chemicals in pressure treated lumber will dissolve the aluminum in a very very very short time . You will have holes in the hull in a few weeks
  14. Scott Danforth

    Four Winns H190 Trailer bunks

    You can. Use plastic pads vs carpet. But the bunks themselves need to be lumber Cypress is really good. Never use pressure treated with aluminum boats
  15. Scott Danforth

    Starter Slave Solenoid

    Follow the yellow with red stripe wiring from the starter.
  16. Scott Danforth

    evinrude/johnson v8 buying

    Many parts are NLA. May be easier finding EFI parts for a Ford powered Mid 90s OMC IO than parts for one of the old Johnnyrude V8s
  17. Scott Danforth

    2018 rinker ex32

    Depends on the slide bolt. Some are a set screw with a locking nut. Some are just a set screw Some do not have a friction screw
  18. Scott Danforth

    2018 rinker ex32

    Is there a friction screw on the slide bolt?
  19. Scott Danforth

    76 OMC 175 starting

    Did you pre-fill the fuel filter? Cranking about 10 seconds would do it if you pre-filled the filter If not. Crank for 20 seconds, rest for a minute. Repeat as needed.
  20. Scott Danforth

    Changing throttle styles

    grab base of throttle handle and pull outward
Top